another question about rotary cutters
#1
Senior Member
Thread Starter
Join Date: Jan 2008
Location: wisconsin
Posts: 490
I also have a fiskars like bevanger ( I am on my third one) but for some reason, the nut that holds the blade together keeps coming loose. :( Does anyone else have that problem or am I doing something wrong?
It's a little frustrating as the blade wobbles and makes a bad cut when it loosens up. Does this make any sense to anyone? Thanks for any help or suggestions. Laurilli
It's a little frustrating as the blade wobbles and makes a bad cut when it loosens up. Does this make any sense to anyone? Thanks for any help or suggestions. Laurilli
#5
If I understand you correctly, the nut is working itself loose from the screw.
If that's the case wrap some plumber's tape around the threads of the screw and replace the nut. That should help tighten it up so the nut stays put until you want it to move. Good luck!
If that's the case wrap some plumber's tape around the threads of the screw and replace the nut. That should help tighten it up so the nut stays put until you want it to move. Good luck!
Thread
Thread Starter
Forum
Replies
Last Post