Border print table runner
#2
I've made the runner a few times. I look at the striped fabric to determine the width of the repeat, plus I want at least three repeats across the width. I decide the cut width for each strip, this is usually narrower than the full repeat. Cut three strips the same size. Place two right sides together, cut at 60 degree angle on each keeping in mind the direction of the angle. Fold the remaining strip in half then half again and cut 4 equalateral triangles. I think it still sounds confusing - sorry
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
2
09-23-2011 07:06 PM
craftybear
Links and Resources
11
09-04-2011 05:01 PM