Correction to BLOCK magazine/book
03-16-2014, 11:14 AM
#1
Junior Member
Thread Starter
Join Date: Nov 2011
Location: Ashland, Wisconsin
Posts: 170
Correction to BLOCK magazine/book
I was reading another forum and saw a post that there is an error in the instructions in BLOCK magazine for one pattern. I thought I would share it here.
Page 55 photo #1 says to square the pinwheel block to 11 3/4 but the written instructions on page 53 say to square to 12 3/4.
12 3/4 is the correct measurment.
And here is one more correction to a pattern:
On page 63 the written instructions (2 Layout) says the orientation with corners in the upper right and lower left. That way the charms will fall from the upper left corner of the quilt to the bottom right like the photo on page 60.
But if you position the blocks as shown in photo 4 the charms will fall diagonally from the upper right to the bottom left!
Page 55 photo #1 says to square the pinwheel block to 11 3/4 but the written instructions on page 53 say to square to 12 3/4.
12 3/4 is the correct measurment.
And here is one more correction to a pattern:
On page 63 the written instructions (2 Layout) says the orientation with corners in the upper right and lower left. That way the charms will fall from the upper left corner of the quilt to the bottom right like the photo on page 60.
But if you position the blocks as shown in photo 4 the charms will fall diagonally from the upper right to the bottom left!
03-16-2014, 11:43 AM
#4
Junior Member
Thread Starter
Join Date: Nov 2011
Location: Ashland, Wisconsin
Posts: 170
GeriB, what errors did you find? Can you list them here so we all will be warned and can make corrections?
dakotamaid, I don't know where to find a list of errors, I just read about these errors on MSQC's forums.
dakotamaid, I don't know where to find a list of errors, I just read about these errors on MSQC's forums.
03-16-2014, 06:14 PM
#7
Super Member
Join Date: Jun 2011
Location: Illinois
Posts: 9,018
Sorry, but I have advised not to, but in the meantime I have gone to the MSQC forum and there is a discussion there about what I found and a few more found by others. So my suggestion to all interested is to go to that website and find the errors/ corrections. That is what I am going to do.
Thread
Thread Starter
Forum
Replies
Last Post
