Extension Sewing Table DIY
#1
Member
Thread Starter
Join Date: Feb 2020
Posts: 3
Extension Sewing Table DIY
Hello! I'm thinking about getting a piece of acrylic cut to use for a sewing extension table, but I'm stumped on what to use for legs and how to attach them. Does anyone have experience with this project?
#3
Super Member
Join Date: Dec 2010
Location: Chula Vista CA
Posts: 7,403
My extension tables have a tube for the legs and a long screw that goes thru a rubber thing and up thru the tube and screws into the acrylic. The screw can be used to level the table. I would have the place cutting your table to drill the screw holes. (They don't go thru just enough to attach the legs.)
Last edited by quiltingcandy; 02-17-2020 at 11:47 AM.
#6
#8
Here are few DIY table extensions. You might find info in them for what you are wanting to do. I just "googled" how to make your own sewing machine extension table and found these & lots more. There are also you-tubes available to watch.
http://spontaneousthreads.blogspot.c...46827296925916
https://quiltingjetgirl.com/2019/07/...able-tutorial/
https://feltmagnet.com/crafts/quiltingtable
https://www.andsewwecraft.com/2013/0...tension-table/
https://www.ehow.com/how_7716176_mak...lexiglass.html
Something like these leveling feet could be used to screw into blocks or wooden dowels for your feet & you could adjust them to get them level.
https://www.lowes.com/pd/Waxman-4-Pa...E&gclsrc=aw.ds
http://spontaneousthreads.blogspot.c...46827296925916
https://quiltingjetgirl.com/2019/07/...able-tutorial/
https://feltmagnet.com/crafts/quiltingtable
https://www.andsewwecraft.com/2013/0...tension-table/
https://www.ehow.com/how_7716176_mak...lexiglass.html
Something like these leveling feet could be used to screw into blocks or wooden dowels for your feet & you could adjust them to get them level.
https://www.lowes.com/pd/Waxman-4-Pa...E&gclsrc=aw.ds
Last edited by osewme; 02-17-2020 at 04:04 PM.
#9
I bought the sew steady extension table. I had it made for a certain machine. After I bought a new machine I had to have the hole cut bigger for the machine. By luck we knew a man that cut that hole with a water jet. It fits perfectly. I doubt many people would know how to do that.
#10
Super Member
Join Date: May 2017
Location: Sunny Florida
Posts: 4,434
You can buy the feet that are used on the tables. Look on the site and replacement parts.
One thing to check is the heigh or length of the adjustable screw. It can be wobbly if you have them extended all the way. In other words, add some allowance for strength.
One thing to check is the heigh or length of the adjustable screw. It can be wobbly if you have them extended all the way. In other words, add some allowance for strength.