Hanging cutting mat
#11
Super Member
Join Date: Aug 2010
Location: Kansas City, Missouri
Posts: 1,040
#12
Same here. I've always hung them on the wall. Some seldom used ones have hung for months or even years straight and they aren't warped. There's no sunlight on them since they're one the same wall as the window.
#13
Power Poster
Join Date: Mar 2013
Location: Corpus Christi, Tx.
Posts: 16,105
They hang them like that in many of the fabric shops. That is a hanging display hole. Meant for just that.
I bought a new cutting mat, I think 24" x 36 " and didn't think to make sure it fit flat where I kept my old, and smaller mat. Well, it's an inch too big, so I was wondering if hanging it would be a way to store it, without it warping?
It has a hole on one end, like it's meant to be hung, is 10 ft away from a heat vent, and is never in direct sunlight.
It's an Omnigrid, green on one side and gray on the other and it says that both sides can be used
It has a hole on one end, like it's meant to be hung, is 10 ft away from a heat vent, and is never in direct sunlight.
It's an Omnigrid, green on one side and gray on the other and it says that both sides can be used
#16
I have hung some of mine and also have laid some flat under a bed. I have only had one warp and that was a Fiskars brand one. That one was laying flat in the box it came in. None of the my Olfa mats have warped, hanging or flat. I use a pant hanger with little pieces of quilt bat between the clip and mat so it is more secure and hang it on the back of the door.
#17
Super Member
Join Date: Nov 2011
Location: Twin Cities, MN
Posts: 1,141
I stand both of my Green cutting mats on edge between the refrigerator and the wall in our bar area downstairs. (I use the counter top there as my cutting table.) I've been doing this for 4 years and have never had a problem with warping.
#19
I hung mine on the board on the wall and it warped. it was hung with 2 clips so not sure why it warped and others here had no problems. I did try the ideas on here to make it flat again, to no avail.
now I just store them flat on top of the cabinet or on the floor.
now I just store them flat on top of the cabinet or on the floor.
Thread
Thread Starter
Forum
Replies
Last Post
gale
Main
21
11-17-2018 12:00 AM
AntBird
Main
24
01-08-2012 01:16 PM