Help! Trying to remove tiny stitches
#32
Member
Join Date: Jan 2012
Posts: 12
Hope someone on here will have some suggestions for removing teeny tiny, itty bitty stitches. I was going along just fine stitching in the ditch with my walking foot on my grandson's quilt. Got to the end, flipped it around and started sewing the other way. I was about halfway done before I noticed that the previous seam looked all puckered. Long story short, something happened that made the stitches tiny, tiny. Have tried using my seam ripper, but can't really even get the point under them and feel like I am causing damage to the fabric. Got out my magnifier and ried using a straight pin, no luck. Oh, and the really difficult part - it's black thread on black fabric .
Any suggestions will be deeply appreciated.
Any suggestions will be deeply appreciated.
#34
Member
Join Date: Jul 2011
Location: Washington State
Posts: 42
I don't know what kind of machine you have but with mine I often change the stitch length by bumping it with the quilt when I move it around. I've gotten into the habit of visually checking it to make sure I didn't make teeny tiny stitches. It's been known to happen.
#35
Power Poster
Join Date: Mar 2013
Location: Corpus Christi, Tx.
Posts: 16,105
I use my 28mm and do this also. It's quick for me. If afraid of the rotary, you could use the eye of a needle to lift then use the ripper
I use the tiny rotary cutter to take out tiny stitches and big ones too. Once I can get to where the layers can be separated a bit and I can see the stitches holding the layers together, I pull up the top layer and start cutting with the rotary cutter little by little while continuing to pull up on the top layer and holding down the bottom one. Does that make any sense whatsoever? I have become a master at this technique .... which is a sad statement about my sewing/quilting. Good luck and take your time.
#36
I use a razor blade. I pull the seam appart so that I can see the tiny thread. Then I just use the tip fo the razor blade to cut the thread. Go slow. I helps if you have magnifying glasses. Otherwise, I just do it in the best light that I can find.
#37
KLO I use a rotary cutter, the small one would be better but there are some rules to this deal. First, do not let anyone sitting next or in front of you with in a foot or so. No chatting as you are doing this. As you must know the dull blade can be more of a damage than the sharp ones but either way, one needs to be super careful. Then, you get to pull out the stitches one by one but by then, you are ready to sew again. When in our group, I will say don't do this as I am doing but I still do.
#39
Senior Member
Thread Starter
Join Date: Feb 2014
Location: Southern California
Posts: 341
I don't know what kind of machine you have but with mine I often change the stitch length by bumping it with the quilt when I move it around. I've gotten into the habit of visually checking it to make sure I didn't make teeny tiny stitches. It's been known to happen.
Thread
Thread Starter
Forum
Replies
Last Post
AFQSinc
Main
28
08-07-2012 03:31 AM
thequilteddove
Main
9
01-19-2010 07:18 AM