HQ Avante 18 tension mechinisim loose
#1
Member
Thread Starter
Join Date: May 2013
Posts: 3
HQ Avante 18 tension mechinisim loose
The tension mechinisim came loose on my HQ Avante 18 today. Has anyone else had that problem? I was adjusting the tension, and the whole mechinisim started turning. It is like it came loose from the casting of the machine, but has not fallen off. I was hoping to fix it so I could use it over the weekend.
Thanks for any help.
Thanks for any help.
#2
Senior Member
Join Date: Sep 2010
Location: OK
Posts: 701
I don't have this particular brand but the assembly probably has a nut or a set screw since it has to be attached. I know on my Gammill there is a nut that I tighten to secure the assembly but I do have to make sure that the spring is in the correct position.
#3
I don't have the Avante, but have always found HQ very helpful with just a phone call. In one instance I even sent on a picture and they answered right away. I literally can't say enough about their support.
Thread
Thread Starter
Forum
Replies
Last Post
cheryl222
For Vintage & Antique Machine Enthusiasts
4
12-12-2011 10:33 AM