Installing Machine Lift .. In progress
#1
Senior Member
Thread Starter
Join Date: Mar 2011
Location: Org. Texas now Florida
Posts: 847
A few pictures of my working on my Machine Lift being installed.
Still not finished..... I need to have a custom made plexi glass made for the top of the table. I would like to have it cover the entire table, so I can turn it around and it will cover the hole when I push the machine down for storage or use for a table when cutting fabric.
Still not finished..... I need to have a custom made plexi glass made for the top of the table. I would like to have it cover the entire table, so I can turn it around and it will cover the hole when I push the machine down for storage or use for a table when cutting fabric.
measure and remeasure
[ATTACH=CONFIG]186557[/ATTACH]
added brace under the table where the machine goes and also from the back of the desk and also braced from the floor
[ATTACH=CONFIG]186559[/ATTACH]
My son cut the hole for the machine from one of my computer desk
[ATTACH=CONFIG]186564[/ATTACH]
Almost done This plexi glass is from my other machine, I want this new one to cover the top of the desk. I also need to paint the edges and braces.
[ATTACH=CONFIG]186565[/ATTACH]
#10
Senior Member
Thread Starter
Join Date: Mar 2011
Location: Org. Texas now Florida
Posts: 847
We got this one from Rockler.com for 159.00. Plus tax. Then there was the cost of the screws, brace board. 20.00
I already had the table. So, your looking at 200.00 for something you've always wanted.
I can't wait to clean up the room so I can use it. I've been pinning and spraying, (taking over my kitchen counter)getting quilts ready to quilt this past week. I have 3 ready, 2 more to go.
Syl
I already had the table. So, your looking at 200.00 for something you've always wanted.
I can't wait to clean up the room so I can use it. I've been pinning and spraying, (taking over my kitchen counter)getting quilts ready to quilt this past week. I have 3 ready, 2 more to go.
Syl
Thread
Thread Starter
Forum
Replies
Last Post
tranum
For Vintage & Antique Machine Enthusiasts
2
07-16-2016 02:47 PM
Ditter43
General Chit-Chat (non-quilting talk)
15
08-25-2010 10:13 PM