Janome 6600 "Stop for Safety Purpose"
#1
Member
Thread Starter
Join Date: Jan 2015
Location: Northwestern Wisconsin
Posts: 3
Janome 6600 "Stop for Safety Purpose"
Hi, I have a 6600p that I have a "Stop for Safety Purpose" error code. I removed the top, bottom, end and back covers and have cleaned the machine from one end to the other. Checked to make sure there is no thread raped around the tread up linkage or the shaft, oiled all the bushing to make sure the fly wheel turns freely and cleaned both of the sensors with alcohol. I also tried three different pedals and the start stop switch. The strange thing is, you turn the machine on; it starts normal and centers the needle. You hit the start button, needle up/down or pedal, the error code comes up and the needle doesn't move. Take your hand or foot off the pedal or button, 5 or 10 seconds later the error goes away and the normal screen comes up. I'm beginning to think it might be the motor or maybe even the A board. I did remove the belt to see if the motor made any attempt to turn, but it didn't. I work on machines as a hobby, but this one has me stumped. I'm open to suggestions. Thanks
#2
Super Member
Join Date: Mar 2013
Location: Southern Indiana
Posts: 3,111
I have gotten that error before - a few times. I turned off the machine and turned it back on - then everything was fine. Sorry I am no help. I just wanted to let you know that I have seen that error
#3
Senior Member
Join Date: Jan 2013
Posts: 990
I have gotten that error message once on my 7700. When I checked, the bobbin thread was jammed up (I was also sewing some very thick seams - drapery pleats). Check your bobbin case for jamming and also try a new needle. I think the machine senses a jam (motor torque too high) and throws that error.
#5
Senior Member
Join Date: Dec 2016
Location: Upstate SC
Posts: 683
Page 92 of my owners manual says to check the feed dogs, the bobbin winder, and any threads around the thread cutter in the bobbin area. It also says turn off and wait 15 seconds before turning back on.
If that doesn't do it, I would take in for service.
Good luck. the 6600 generally has very few issues.
If that doesn't do it, I would take in for service.
Good luck. the 6600 generally has very few issues.