Janome MC 10000 error message
#1
Senior Member
Thread Starter
Join Date: Jan 2010
Location: FL
Posts: 904
Janome MC 10000 error message
Just received this beauty. turned it on and get message " Raise presser foot and needle bar, then turn power on again. 01"
Both presser foot and needle are up.
Help anyone?
Both presser foot and needle are up.
Help anyone?
#2
Super Member
Join Date: Oct 2010
Location: Tennessee, UC area
Posts: 1,584
My Brother ULT sew/emb machine did the same.."raise presser foot" Couldn't do anything with it...off to repair shop! I think they told me they put a new spring in the presser foot lift. Was repaired right away.
#5
Super Member
Join Date: May 2017
Location: Sunny Florida
Posts: 4,431
Is this a combo machine with an EMB unit? Did you try turning off/on the machine? Try turning the hand-wheel to see if the machine re-sets.
There may be a lever on the back that you can raise. It goes higher than the machine setting. Look at page 20 in the manual.
Good luck!
There may be a lever on the back that you can raise. It goes higher than the machine setting. Look at page 20 in the manual.
Good luck!
#6
Senior Member
Thread Starter
Join Date: Jan 2010
Location: FL
Posts: 904
Thanks all. I volunteer at Women In Distress thrift store. I fix and price the sewing machines, quilt fabric and notions. Last week three machines were donated. I cleaned and verified if the machines work and research prices. I only have vintage machines, so the Janome is new to me to work on. Rhonda K I was looking at page 20 and have not been able to figure that out yet. It is a combo machine.
I'll keep trying. Again, thanks.
I'll keep trying. Again, thanks.
#9
Member
Join Date: Jul 2012
Location: California
Posts: 53
This happens to me occasionally and is usually cleared by putting the presser foot down, turning off the machine, turn the machine on again, and raise the presser foot. Also try pressing the needle up/down button.
#10
Senior Member
Thread Starter
Join Date: Jan 2010
Location: FL
Posts: 904
Kplumbridge, when I leave the presser foot down, I get message that says "raise presser foot." Then when I raise presser foot it makes a grinding noise. I also tries the neddle up/down. No change.
All suggestions welcome.
All suggestions welcome.
Thread
Thread Starter
Forum
Replies
Last Post