Juki Miyabi J-350QVP S sit down free motion
02-08-2022, 06:54 PM
#41
Senior Member
Join Date: Jan 2013
Posts: 990
I just got my Juki long arm and have set it up. I had some problems with the tension also. I tightened the screw on the bobbin case a little which helped some. I noticed that the shaft that holds the pressure foot had marks on it. I lowered the foot down a notch and it is working good.
OK now I have to ask. My new Juki hat a throat plate on that is not even with the table top. shouldn't it be even? PLEASE HELP.
OK now I have to ask. My new Juki hat a throat plate on that is not even with the table top. shouldn't it be even? PLEASE HELP.
02-09-2022, 08:58 AM
#42
Senior Member
Thread Starter
Join Date: Apr 2019
Location: USA
Posts: 772
How far below the tabletop does your needle plate sit?
My machine came with the Juki slider top that covers the entire table (excluding the add on wings). The 1/16" thick slider brings the needle plate even with slider surface. One dealer I visited sold the slider separately, but mine was included with the machine, so I'm not sure about the cost.
It also looks like the machine has little black feet on the corners. I don't know if these are attached to the machine or were added by the dealer when he set the machine up in my home because I've never lifted the machine.
My machine came with the Juki slider top that covers the entire table (excluding the add on wings). The 1/16" thick slider brings the needle plate even with slider surface. One dealer I visited sold the slider separately, but mine was included with the machine, so I'm not sure about the cost.
It also looks like the machine has little black feet on the corners. I don't know if these are attached to the machine or were added by the dealer when he set the machine up in my home because I've never lifted the machine.
Last edited by BonnieJP; 02-09-2022 at 09:07 AM.
