Machine embroidery
#1
Member
Thread Starter
Join Date: Jan 2010
Location: Butte, Montana
Posts: 64
I have a Bernia deco 330 with a 5x7 and 5x4 hoop and a Brothers Disneywith a 4x4 hoop.
I stitched the same design with all 3 hoops using the iron on stablizer and same fabric.
MY PROBLEM is that the 5x7 outlined very faint and didn't seem to be in the right spots all the time.
5x4 was a little better and the Brothers was GREAT.
Any ideas what is wrong?
I stitched the same design with all 3 hoops using the iron on stablizer and same fabric.
MY PROBLEM is that the 5x7 outlined very faint and didn't seem to be in the right spots all the time.
5x4 was a little better and the Brothers was GREAT.
Any ideas what is wrong?
#5
Super Member
Join Date: Mar 2010
Location: Tennessee
Posts: 2,189
I have had this problem too. For me it is the hooping. When the design is stitched out it draws the fabric up just a little bit then the outline is off. Practice on hooping has helped me, even though I'm still not perfect. Go to annthegran.com and look on her blog (at least I think that's where I found good information) and look for hooping. That's a great site for embroidery people. Good luck!
#7
It could also be how fresh is your needle in each machine. The hooping is alot of it along with the design type! It may have been created in one type then converted to the other and in the conversion depending on the software to convert it changed it.
Thread
Thread Starter
Forum
Replies
Last Post
knotsoflove
Machine Embroidery
30
07-02-2022 09:02 AM
skdenbow
Main
25
05-03-2016 09:21 PM
CIGAINEROJD
Main
0
02-26-2011 09:39 AM
craftybear
General Chit-Chat (non-quilting talk)
1
01-15-2011 04:13 AM