Making a finished 12.5" disappearing 9 patch...
#1
Making a finished 12.5" disappearing 9 patch...
Can anyone tell me what size blocks to use in making a finished 12.5" disappearing nine patch? The ones I've done end up only 12".... Grr......
#2
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
You start with 3 patches across. If you want to add a half inch, you would need to divide that by 3 which isn't pretty. I would add a quarter inch to each of your starting squares, then trim the final block. Do a sample with scrap fabric to verify.
#3
Power Poster
Join Date: Jun 2011
Location: Southern California
Posts: 19,127
This is just a guess but when you cut your squares up, the outside corner stays the same size. So I think that your squares need to be cut at 8.5" I would just find a piece of paper and draw it out. When you cut down the center, your strip (the one that looks like sashing) should be 4.25"
OOPS, that is a 12" finished. That is going to be difficult because when cutting the center of the 9 patch, the size of the square needs to be divisable by 3. Hope that makes sense.
OOPS, that is a 12" finished. That is going to be difficult because when cutting the center of the 9 patch, the size of the square needs to be divisable by 3. Hope that makes sense.
Last edited by ManiacQuilter2; 03-30-2016 at 04:33 AM.
#4
Found this - right here on the QB! I have not tested it yet. I would make it larger and trim all blocks down.
http://www.quiltingboard.com/links-r...t-t150081.html
Nan
http://www.quiltingboard.com/links-r...t-t150081.html
Nan
Last edited by QuiltnNan; 03-30-2016 at 06:27 AM. Reason: remove copyright image
#5
Super Member
Join Date: Jun 2010
Location: The Deep South near Cajun Country, USA
Posts: 5,434
#6
'Cause I'm using 12" finished blocks. I'm making graduation quilts of various themed blocks for DGKs. I guess if you were making a quilt using all DP9 patch blocks, the chart would be helpful but I just want to make 1 block.
I meant 12.5" unfinished - 12" finished .... Dummy me...
I meant 12.5" unfinished - 12" finished .... Dummy me...
Last edited by ljptexas; 03-30-2016 at 06:12 AM.
#9
I tried using a 4 3/4" block & it came out to 12.5" unfinished!! Yeah, happy, happy, happy!!!!!
'Cause I'm using 12" finished blocks. I'm making graduation quilts of various themed blocks for DGKs. I guess if you were making a quilt using all DP9 patch blocks, the chart would be helpful but I just want to make 1 block.
I meant 12.5" unfinished - 12" finished .... Dummy me...
I meant 12.5" unfinished - 12" finished .... Dummy me...
Thread
Thread Starter
Forum
Replies
Last Post
bearisgray
General Chit-Chat (non-quilting talk)
65
02-01-2024 09:04 AM
bearisgray
General Chit-Chat (non-quilting talk)
21
05-09-2017 05:30 PM
tothenci
Links and Resources
18
10-08-2012 05:34 PM