Pattern instructions for a Windmill Block by Pink Caramel
#11
I've made some practice blocks of this pattern. You need to use partial seams, but it's not too bad. Cut the pieces, then (referring to Barb's pic) Partially sew the red triangle to the center square: Start at the corner of the square and sew about half of one side of the square. Next add the Dk green triangle, no partial seam for this one, sew it to the center square and the red triangle. Same with the lt green and brown patches. Then finish the red seam.
#12
Member
Join Date: Mar 2019
Location: Waynesville, NC
Posts: 5
Wind Mill Block
I also drew the block in EQ7 and was able to change the size of the block and print as a foundation block. If you go to options in the print section, uncheck the block for Separate Units, you will then get the block as a foundation block for piecing. Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post