I have always threaded with the foot up.
|
Yes you must thread the machinde with the pressure foot up but you can lower it when it comes to threading the needle.
|
Have been threading Berninas for 15 yrs so had to think about how I do it. I thread the machine itself with presser foot up, then put presser foot down to thread needle only. No problems.
|
Every machine since the beginning has to have the presser foot up when threading. Stop and think about it. When the foot is down the discs are tight together for tension. The thread can't get in between them. Raise the foot and they open and the thread goes in between. Then when you lower the foot to sew you have tension on the thread and all is happy. This is every machine out there.
|
Originally Posted by feline fanatic
When threading the machine I always have my pressure foot up for the exact reason Ghost Rider explained. However, when threading my needle I have done it with pressure foot down but only dropping the pressure foot after I have taken enough slack in my thread that I may need. I never pull my thread through the machine when the tension disks are engaged (ie when pressure foot is down). I always raise it before pulling any thread. So much so that it is engrained habit now.
|
Originally Posted by kathy
I can see that if you thread any machine with the foot down the thread may not go into the tension discs correctly, but I sure can't figure it causing any OTHER problems, very strange if it's true.
But :-( making the timing off because you don't raise the pressure foot when threading... that does seem strange!!! |
Originally Posted by ghostrider
When the foot is down, the tension discs are engaged and you are putting undue stress on the thread and the discs when you pull it to thread the needle. This is true for any sewing machine. I think your repair guy's explanation is right on and you should listen to him. I never thread machines with the foot down...it's like pushing a car with the brakes on. :D
|
If you thread with the foot down, the tension disc is closed and the threads can't get between them, and there won't be any tension on the thread, causing a mess when you start to sew. When the presser foot is up, the thread GOES between the discs and when the foot is lowered, the correct tension is put on the thread to form a correct stitch. This goes for ANY machine - not just a Bernina.
|
Huh! Maybe that's why I've been having problems with my Bernina. I bought a gently used 440EE Aurora right after Christmas. Most of the time, the tension is fine, but not always. That may be when I threading it with the foot down. I'll give it a try.....
Thanks Lindakaycat |
Foot down, no problems.
|
All times are GMT -8. The time now is 11:20 PM. |