Um, not sure, and not as experienced as some on here, but did you add in the HST's or smaller geese below/above/to the sides of the Flying Geese or the 3 x 3" center square accounting for the 6 in the directions?
Out of one-1 1/2"x 3" block you get two geese because you cut it in half. This accounts for the 6 larger geese. You then cut three of these in half again for the smaller triangles. The pattern requires a total 6 which makes sense.
As far as the measurements, I am not that good at the math part. Just ask my math teacher :roll: :oops:

Can you possible upload that file again in a different format? Like a PDF file? I don't have Word, nor do I have a converter for a docx file, and I'd prefer not to install a program just to convert one file.
Thanks so much.
Tracy

I can convert the file.......but it seems to be the whole page and not just the diagram..
If that's ok, I'll attach it ?

can you open this?

The PDF file worked. Thanks.

Now...as for your question:
Where you put the 2 red triangles, yes...that will be part of one of the geese. The 2 red triangles and the other part (where the words are presently) will be a one flying geese (or should I say one goose :P )

Does that make sense?