Question about doing the quilting part
#31
Power Poster
Join Date: Dec 2008
Location: Western Wisconsin
Posts: 12,930
Originally Posted by Metanoia
So far I think that the process is that you lay out the top, bottom and batting, and leave enough batting and bottom incase of a little shrinkage. Then the whole lot is pinned with safety pins starting from the centre out.
Then is it ok to put this through my sewing machine?
How do you do things like straight lines if you're in the centre of the quilt and have no machine lines to help line everything up?
Any tips for tackling this? I dont' want to ruin my quilt top when I get up to this stage.
Then is it ok to put this through my sewing machine?
How do you do things like straight lines if you're in the centre of the quilt and have no machine lines to help line everything up?
Any tips for tackling this? I dont' want to ruin my quilt top when I get up to this stage.
I am not a big fan of stitch-in-the-ditch, perhaps because I am too much of a perfectionist. For me to find SID pleasing, the stitching has to be exactly where it is supposed to be. I find that very nerve-wracking to do, especially with a large quilt. Mine always seems to want to wander an eighth of an inch on either side of the line.
IMO, the easiest and most pleasing way to machine quilt is curving, wavy lines using a walking foot and the feed dogs up. The machine controls the stitch length this way (make it slightly longer than you would normally use for stitching) and you don't have to keep your eye on the "ditch" and make sure you're not running a little too much to one side or the other. The walking foot allows you to make loose, easy curves as you go. I would probably do cross-hatching with curving lines going both top/bottom and left/right. (It would be even more interesting doing the curving lines from corner to corner; however, for this it would be a very good idea to starch your top and backing heavily before layering. Starch would prevent distortion from stitching on the bias.)
Whatever machine quilting method you decide to use, you want to start in the middle of an edge and go from one side of the quilt to the other. This means you need to fit half the quilt under the arm of your machine. I have tried many methods and for me the easiest is to loosely accordion pleat the quilt as it goes under the arm.
Love your blocks!
#32
Power Poster
Join Date: Nov 2007
Location: SW Iowa
Posts: 32,855
When I did my first quilt I drew lines with a disappearing pen and followed it. Your block look to me like you should outline the pattern of the pieces. But of course it is up to you. By all means use your machine. And most of all, have fun.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
5
09-25-2011 04:02 PM
craftybear
Links and Resources
10
06-10-2011 03:13 AM
craftybear
Links and Resources
2
02-19-2011 07:24 AM