Sandwiching Problem
01-21-2018, 09:57 AM
#12
Super Member
Join Date: Mar 2008
Location: Pacific NW
Posts: 4,394
For spray basting I lay the batting on the backing, then fold the batting back halfway, spray either batting or backing (your preference) then starting from the middle where the batting is folded back carefully lay batting back down a little at a time, smoothing as I go until I get to the edges. Repeat for other half. Then lay top on and do same thing.
Never had problems with puckers doing it this way.
Rob
Never had problems with puckers doing it this way.
Rob
I hope you find a happy solution.
01-21-2018, 06:07 PM
#16
Super Member
Join Date: Dec 2017
Location: Southwest Idaho
Posts: 6,000
I don't bother to clamp or tape. I lay the back down face down, smooth the batting over it and then lay the top on. I do it that way whether I'm spray basting or pin basting. The key is to continually smooth it as you go, particularly if pin basting. For Pin Basting I periodically slip my hand under the sandwich to make sure the pins are going through all three layers.
For spray basting I lay the batting on the backing, then fold the batting back halfway, spray either batting or backing (your preference) then starting from the middle where the batting is folded back carefully lay batting back down a little at a time, smoothing as I go until I get to the edges. Repeat for other half. Then lay top on and do same thing.
Never had problems with puckers doing it this way.
Rob
For spray basting I lay the batting on the backing, then fold the batting back halfway, spray either batting or backing (your preference) then starting from the middle where the batting is folded back carefully lay batting back down a little at a time, smoothing as I go until I get to the edges. Repeat for other half. Then lay top on and do same thing.
Never had problems with puckers doing it this way.
Rob
01-22-2018, 05:39 AM
#20
Super Member
Join Date: Dec 2012
Posts: 1,857
When I lived in a very small apt., I purchased a couple pieces of paneling (the old fashioned thin stuff used in dens). I cut them to 5' long (the store will do that for you). I kept these under my bed and when I needed a large cutting area, I put them on the bed and then lay my cutting mat on top of them. Not the most ideal, but it worked fine. They gave me a fairly firm underlayer and they stored easily out of site.
Thread
Thread Starter
Forum
Replies
Last Post
