Sewing binding to the back first
#25
Originally Posted by qbquilts
I tried it, but didn't like my results. I did recently come across this tutorial that sews the binding back to front and then stitches it down by machine. It creates a faux piping look and you stitch in the ditch of the "piping" and the "binding" using a regular "stitch in the ditch" stitch.
http://tlcstitches.blogspot.com/2010...-tutorial.html
http://tlcstitches.blogspot.com/2010...-tutorial.html
#26
I like to sew the binding to the back and machine stitch on the front. The only problem I had was that I did not like the way the back looked. Sometimes I caught the binding and sometimes I did not. I Started using my stitch in the ditch foot to sew the front down. I barely cover the stitching line (that attached the binding), and set my needle to sew anywhere from an 1/8 to a 1/4 inch from the edge of the blade. This distance depends on how wide my binding is. Not all "stitch-in-the ditch" feet allow for needle movement side-to-side, so be sure yours does. Starting with heavily starched binding helps. The only pins I use are at the corners. The back of the binding ends us looking just as nice as the front. Below are a few pictures.
Start with all four corners already mitred and pinned down.
[ATTACH=CONFIG]253619[/ATTACH]
Getting ready to hold the mitre down while working to turn the corner.
[ATTACH=CONFIG]253621[/ATTACH]
Holding the corner, sew to the fold, then stop with needle down before turning the corner.
[ATTACH=CONFIG]253623[/ATTACH]
Turning the corner.
[ATTACH=CONFIG]253624[/ATTACH]
Final result on back and front.
[ATTACH=CONFIG]253630[/ATTACH]
#29
Originally Posted by barbrdunn
I like to sew the binding to the back and machine stitch on the front. The only problem I had was that I did not like the way the back looked. Sometimes I caught the binding and sometimes I did not. I Started using my stitch in the ditch foot to sew the front down. I barely cover the stitching line (that attached the binding), and set my needle to sew anywhere from an 1/8 to a 1/4 inch from the edge of the blade. This distance depends on how wide my binding is. Not all "stitch-in-the ditch" feet allow for needle movement side-to-side, so be sure yours does. Starting with heavily starched binding helps. The only pins I use are at the corners. The back of the binding ends us looking just as nice as the front. Below are a few pictures.
i am sooo impressed! I do pretty good until the corners, but I am getting better.
Thread
Thread Starter
Forum
Replies
Last Post
luvTooQuilt
Member Swaps and Round/Row Robins
30
12-18-2013 04:22 PM
craftybear
Links and Resources
1
10-26-2011 03:25 PM
irma tapia
Main
77
03-26-2011 11:24 AM
craftybear
Links and Resources
3
12-25-2010 09:49 PM