Sewing the edges of a quilt together before binding?
#1
Super Member
Thread Starter
Join Date: Jan 2015
Posts: 2,867
Sewing the edges of a quilt together before binding?
Do you sew the edges of a quilt together after quilting, before binding? I usually do not, but I have had the back move a little occasionally. This quilt has thicker batting and I feel the need to align the edges before the binding goes on. Any way to get around one more step to finishing?
#5
Super Member
Join Date: May 2017
Location: Sunny Florida
Posts: 4,434
Yes, I use a zig zag stitch with a very small width so it's almost straight. It locks down the edges of the quilt. The binding looked so much better on my last two quilts.
Honestly, the extra step may have taken 10-15 minutes extra.
Honestly, the extra step may have taken 10-15 minutes extra.
#7
Do you sew the edges of a quilt together after quilting, before binding? I usually do not, but I have had the back move a little occasionally. This quilt has thicker batting and I feel the need to align the edges before the binding goes on. Any way to get around one more step to finishing?
#8
Power Poster
Join Date: Apr 2011
Location: Ontario, Canada
Posts: 17,861
I do the same, except just stick with a straight stitch.
I've even stitched around again, after the binding is machine stitched in place,
before I start the hand stitching of the binding.
Either or both, help hold all the layers together and definitely give a nicer finished binding.
As RhondaK said, it only takes a few minutes, and the results "pay" for the time!
#9
Power Poster
Join Date: Dec 2008
Location: Western Wisconsin
Posts: 12,930
I avoid this problem by not trimming the quilt before adding binding. Instead of cutting, I mark the cutting line. (I use a regular Sharpie permanent pen because I want the marking highly visible but do not want any chance of it bleeding.) I align the raw edge of the binding with this line to sew it on. After the binding is sewn on one side, I trim the quilt sandwich to fit. (Be careful not to cut through the binding at the corners! That would create holes.)
It sounds counter-intuitive, but I found that this approach eliminates the issue I used to have with having an occasional edge flip on me when sewing on the binding. Also, it lets me adjust the depth of the batting so it fills the binding the way I want it.
If you prefer to baste the edges, I recommend doing this basting before trimming. Being able to pin to the right of the machine basting line helps keep everything even.
It sounds counter-intuitive, but I found that this approach eliminates the issue I used to have with having an occasional edge flip on me when sewing on the binding. Also, it lets me adjust the depth of the batting so it fills the binding the way I want it.
If you prefer to baste the edges, I recommend doing this basting before trimming. Being able to pin to the right of the machine basting line helps keep everything even.
#10
Senior Member
Join Date: Jul 2015
Posts: 594
I have begun basting with a large stitch around the quilt edge before I start putting the binding on. It does keep the back in line, but occasionally I end up with a little pucker at the end of the binding process. (I bind by machine; can't hand sew anymore)
I think the pucker is because the binding is still a little stretchy, but the basted edge of the quilt is not stretchy any more. I might need to apply a little more tension to the binding when sewing it on.
I think the pucker is because the binding is still a little stretchy, but the basted edge of the quilt is not stretchy any more. I might need to apply a little more tension to the binding when sewing it on.
Thread
Thread Starter
Forum
Replies
Last Post
oldquilter
Main
41
10-02-2014 11:05 AM
craftybear
Links and Resources
11
02-15-2011 09:33 PM