Are they worth the money?
#31
I use a piece of Headliner--foam backed knit fabric that is made to go in the ceiling of a car. It's available at Joann's for around $15 a yard (I think, it's been a while). Much cheaper than Steady Betty and you can have any size you need.
#33
Power Poster
Join Date: Jan 2011
Location: Southern USA
Posts: 16,515
#34
Super Member
Join Date: Nov 2010
Location: Littlefield, TX, USA
Posts: 1,077
Get a board (I used a shelf from a little cabinet) & cover it with two layers of cotton batting or 4 layers of cotton flannel....cover the batting/flannel with duck or medium density canvas ( I used a cheap muslin that felt real heavy). This is the perfect ironing surface & easily replaced when it gets soiled. If you want the silver heat resistant cover...use a piece from an old ironing board cover...usually the part at the wide end of the board is in fairly good shape.
#35
Super Member
Join Date: May 2012
Location: Central Wisconsin
Posts: 4,391
http://www.amazon.com/Steady-Betty-1...sortBy=helpful
This is the link that shows the Steady Betty for $90.00. And 29 cents! Our quilting group has the foam on their Big Board, and I do not like it. Maybe a small piece of it would be OK, but for large pieces, I want the fabric to pull up and over the board without resistance.
As for seams, I usually try to make the scant quarter inch seam. I've heard that if you make all your seams the same, it won't matter too much. But I made a quilt from "Man Sewing" which joined a lot of strips, then cut that resulting piece into equal squares. By using the scant seam, my piece was wide enough so that I couldn't get three of the squares out of one piece. What a waste. I did save it though. I had to piece a few of the ends of strips. When I press those seams open, they don't show much. After the quilting, you won't know, but that was a lot of work!
This is the link that shows the Steady Betty for $90.00. And 29 cents! Our quilting group has the foam on their Big Board, and I do not like it. Maybe a small piece of it would be OK, but for large pieces, I want the fabric to pull up and over the board without resistance.
As for seams, I usually try to make the scant quarter inch seam. I've heard that if you make all your seams the same, it won't matter too much. But I made a quilt from "Man Sewing" which joined a lot of strips, then cut that resulting piece into equal squares. By using the scant seam, my piece was wide enough so that I couldn't get three of the squares out of one piece. What a waste. I did save it though. I had to piece a few of the ends of strips. When I press those seams open, they don't show much. After the quilting, you won't know, but that was a lot of work!
#37
Super Member
Join Date: Aug 2011
Location: NY
Posts: 2,497
There are two types of 1/4" presser foot type attachments. I found this out the hard way. There's the regular kind and the quilter's 1/4" presser foot. I was in the middle of a project and had to purchase a replacement. Wouldn't you know the regular quilter's assistant was out and as luck would have it, I purchased the wrong one. My block was smaller on the side I pieced after the replacement!
#38
Power Poster
Join Date: Jan 2011
Location: Southern USA
Posts: 16,515
The large one is here: http://www.joann.com/steady-betty-15...y/2409084.html and there is a coupon to use on it to make the price lower. Amazon isn't always the best place to buy especially direct from the dealer.
Thread
Thread Starter
Forum
Replies
Last Post
Prism99
Main
5
08-07-2009 11:59 AM