trouble with bobbin case for HQ 16
#1
Senior Member
Thread Starter
Join Date: Jan 2010
Location: Arkansas
Posts: 952
trouble with bobbin case for HQ 16
I think I may need a new bobbin case for my HQ16. After I got my bobbin loaded, and tested it on my Towa Gauge, which I always use with great results, I found that I couldn't tighten/adjust the little screw that does this on my bobbin case. As tight as I could tighten it, it still wasn't enough. If I loosen my top tension in order to co-ordinate with my bobbin that tight, then I get a terrible stitch. And, it was all working just fine, the last quilt I quilted about a week ago!! I guess the only place I should order a new case is from Handi-Quilter????? Or are they any cheaper elsewhere and would it work for my machine? BTW, I've checked for trapped lint, etc....nothing.
#2
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
Here's a recent post. Looks like your Handi-Quilter dealer is the way to go.
http://www.quiltingboard.com/main-f1...ml#post6964412
Also, there are 2 screws on the case. Double check that you are adjusting the correct one!
http://www.quiltingboard.com/main-f1...ml#post6964412
Also, there are 2 screws on the case. Double check that you are adjusting the correct one!
#3
Super Member
Join Date: Sep 2010
Location: Myrtle Beach, SC
Posts: 8,139
I dropped mine on the floor (cement) and one of the screw actually chipped. After that it wouldn't work, so I bought a new one.
I tried a cheap one - not HQ specific - it worked for awhile, but then it became impossible to set the tension. So go with the HQ.
Personally, I think it is priced way too high, but I guess everybody has to make money somehow. If it were less costly, I'd have bought several for those "murphy's law" days we all have from time to time!
I tried a cheap one - not HQ specific - it worked for awhile, but then it became impossible to set the tension. So go with the HQ.
Personally, I think it is priced way too high, but I guess everybody has to make money somehow. If it were less costly, I'd have bought several for those "murphy's law" days we all have from time to time!
#4
I know this company do a lot of custom long arm accessories. I bought from them a case for my Viking 18x8. You could check with them about your HQ16:
http://www.finishingtouchesquiltings...1060230?page=1
http://www.finishingtouchesquiltings...1060230?page=1
Thread
Thread Starter
Forum
Replies
Last Post
J Miller
For Vintage & Antique Machine Enthusiasts
11
10-17-2012 08:30 PM
miriam
For Vintage & Antique Machine Enthusiasts
4
07-28-2012 03:51 PM
MrsBoats
For Vintage & Antique Machine Enthusiasts
2
04-25-2012 02:20 PM
craftybear
Links and Resources
1
10-09-2011 05:03 PM