using table for layering quilt
#42
Super Member
Join Date: Aug 2011
Location: Missouri
Posts: 1,250
I use my glass dining room table. And use masking tap to hold the backing taut, add the batting and quilt top and pin from the center out. I have only done crib/lap size quilts this way. Anything bigger I send to my long arm quilter.
#43
Originally Posted by paulswalia
I use a carpeted floor all the time! Lay your backing down, wrong side up and pin it to the carpet in the corners and a couple of places along the sides, making sure it is flat and tight. Layer your batting and then the top, smoothing out each layer. THEN (this is how it works), slide a cutting mat on the carpet, under the backing and use the mat as something to pin against so you don't catch your carpet. I just did it last night - works great!
#44
Super Member
Join Date: Aug 2010
Location: Kansas City, Missouri
Posts: 1,040
Originally Posted by JENNR8R
Harriet Hargrave recommends doing it on a table. She describes it in detail in her book "Heirloom Machine Quilting."
She recommends taping a toothpick on the centers of the top edges of the table. You can then feel through the layers to know exactly where the center is to place your sandwich layers.
She recommends taping a toothpick on the centers of the top edges of the table. You can then feel through the layers to know exactly where the center is to place your sandwich layers.
#45
I have the same problem, certainly no wall. When I layer mine I have to work off of a kitchen island which is 4 x 6 ft, large but not large enough. Sometimes I have to smooth out layers and re layer because there are still buckles and wrinkles and my bar top is granite, do I dont think the problem is the carpet so much. Wish I could figure out a wall somewhere, but no luck.:)
#46
Super Member
Join Date: Feb 2011
Location: Carlisle, PA
Posts: 1,964
That's where an extra set of hands comes in - I call for my husband or my quilting buddy!!
This is what I was thinking of doing. Doesn't the quilt tend to slip off once you get near the edge and most of it is off the table?
Originally Posted by annesthreads
Originally Posted by dakotamaid
I have used my dining room table. I layer all three layers, than start pining, or basting, in the very middle and work out to each side, top and back. I smooth as I go. I know some will clip the backing to the edge of the table to begin but I don't. The weight of the hangover seems to keep it smooth. Once the quilt area on top of the table is basted I move the quilt sandwich one way or the other to continue with the pining or basting. Works or me.
#47
Senior Member
Join Date: Dec 2010
Location: Northwest Texas
Posts: 442
Originally Posted by dakotamaid
I have used my dining room table. I layer all three layers, than start pining, or basting, in the very middle and work out to each side, top and back. I smooth as I go. I know some will clip the backing to the edge of the table to begin but I don't. The weight of the hangover seems to keep it smooth. Once the quilt area on top of the table is basted I move the quilt sandwich one way or the other to continue with the pining or basting. Works or me.
Thread
Thread Starter
Forum
Replies
Last Post