Well I feel like an idiot
#31
Junior Member
Join Date: Jun 2010
Location: Pflugerville, TX
Posts: 230
Oops! Think I'd toss the iron and get another one. I did something similar when very, very tired! I used the can of compressed air to clean out my serger. Right? Wrong!! It was spray adhesive! Ouch!!:( Now I really pay attention to the container!
#32
I was going to suggest vinegar too, it works for everything lol. But if that doesn't work do to the store and get some iron cleaner, they have that. Clean according to directions, then I would fill and dump a few times anyway. I am a over achiever. Hope the vinegar works good luck. Oh by the way, I happen to be the master of all goof ups so don't worry about it.
Rita
Rita
#33
try vinegar & water; more vinegar than water; leave the iron on for a while, at least 1 hour, occassionally turning it to allow it to steam. Then dump what is left, rinse and dump, rinse & dump, then try just water & steam. :wink:
#34
There are products on the market for cleaning the insides of irons to get the white buildup of lime out of them. I don't know the names but perhaps your local hardware store - like a True Value - could help you.
Originally Posted by Butterflyblue
Today I poured about a 1/4 cup of water in my iron and went along my merry way. A few minutes later I noticed a funny smell, but I thought it was some starch that had oversprayed on the ironing board. Later it was worse and I suddenly realized that what I thought was water was flat Sprite.
I rinsed the iron out as well as I could just by pouring water in and dumping it out again, but is there any way to get the inside of the iron clean?
I rinsed the iron out as well as I could just by pouring water in and dumping it out again, but is there any way to get the inside of the iron clean?
#35
Originally Posted by Butterflyblue
Today I poured about a 1/4 cup of water in my iron and went along my merry way. A few minutes later I noticed a funny smell, but I thought it was some starch that had oversprayed on the ironing board. Later it was worse and I suddenly realized that what I thought was water was flat Sprite.
I rinsed the iron out as well as I could just by pouring water in and dumping it out again, but is there any way to get the inside of the iron clean?
I rinsed the iron out as well as I could just by pouring water in and dumping it out again, but is there any way to get the inside of the iron clean?
#37
Through the years I have spent oodles of $$$ on "special" irons only to be disappointed in performance or length of service. I only use a dry iron and a little spritz of water if necessary, never steam when quilting. My latest iron cost $10 at Walmart so when I get mad at it, it will just go in the trash. It's already lasted longer than the last $80 iron.
#38
Originally Posted by Butterflyblue
Today I poured about a 1/4 cup of water in my iron and went along my merry way. A few minutes later I noticed a funny smell, but I thought it was some starch that had oversprayed on the ironing board. Later it was worse and I suddenly realized that what I thought was water was flat Sprite.
I rinsed the iron out as well as I could just by pouring water in and dumping it out again, but is there any way to get the inside of the iron clean?
I rinsed the iron out as well as I could just by pouring water in and dumping it out again, but is there any way to get the inside of the iron clean?
Thread
Thread Starter
Forum
Replies
Last Post
Julie in NM
Links and Resources
8
11-10-2012 09:12 PM
grann of 6
General Chit-Chat (non-quilting talk)
20
11-22-2010 03:03 PM