What is a "float"when cutting 1/2 blocks?
#1
Senior Member
Thread Starter
Join Date: Mar 2011
Location: western n.c.
Posts: 645
What is a "float"when cutting 1/2 blocks?
I am getting ready to make a quilt from Miss Rosie's quilt co.called 4OT, and while reading the cutting requirements it says pieces in the pattern is purposely cut larger to allow for squaring up of the blocks. And the size of the blocks are such that there will be a "float" between point of the inner sq. and the seam line. and the only way to get around that was with a 16th inch measurement or paper piecing.So can someone tell me what is a float in quilting terms?
#3
Super Member
Join Date: Jun 2010
Location: England Alton Towers
Posts: 6,673
I would have thought that the float was going to be more than 1/4inch to allow for trimming. Saying the smaller amount has confused me . Will wait for someone with more knowledge interested in reply.
#6
Super Member
Join Date: Jul 2010
Location: Ohio
Posts: 2,148
Yes that is what it is. There is a small space/ couple of threads or a set measurement between the point and the seam. I made a quilt with "float" space for the points and it looked really nice. (at least I liked the look). It seems easier to have the points float but it is still important to have the space reasonalbly close in disatance. The pattern I followed said that you could have the points either float or not. the difference being in cutting /squaring the block to 1/4" seam allowance. To have the blocks float then you would square the block with 1/2" edges instead of 1/4" and sew the seam 1/4" to allow the block to "float".
#7
Super Member
Join Date: Aug 2010
Location: Piedmont Virginia in the Foothills of the Blue Ridge Mtns.
Posts: 8,562
This is what "float" looks like.
You can use the same idea when setting a quilt "on point" by cutting the setting triangles larger than needed and trimming a bit after the whole top is sewn together. Leave enough 'extra' to allow floating of the design.
Jan in VA
You can use the same idea when setting a quilt "on point" by cutting the setting triangles larger than needed and trimming a bit after the whole top is sewn together. Leave enough 'extra' to allow floating of the design.
Jan in VA
#10
Super Member
Join Date: Feb 2010
Location: Maryland
Posts: 3,586
Thanks Jan! I still didn't understand until I saw the picture
Thread
Thread Starter
Forum
Replies
Last Post
bearisgray
General Chit-Chat (non-quilting talk)
65
02-01-2024 09:04 AM