Excellent job bringing the machine back to life. Mine wasn't as dirty but still needed a good cleaning and oiling. I still need a belt though. I have about fourteen machines and this newest acquisition is among my favorites. It really looks neat with all the levers and such. Mine is also two-tone. Good to hear another person who appreciates good engineering and interesting machines. Have fun.

Very good job. So the grease pot is behind the bobbin case? I am going to get one of these 319's shortly and am glad you showed a picture about the grease pot. I need to learn all I can Thanks for the Great pictures. bannie :thumbup:

I'm not really sure about the grease pot, I'll have to check mine. But the 319W is a really interesting machine. Keep it clean and well lubricated and you should be very happy. Send some pix if you like.

Thanks How often would the cleated belt wear out? Is that a something that rarely happens? bannie

It is to keep the gears lubricated. The pot just had a couple screws holding it on. I pulled them off and cleaned the grease out with a screw driver end - then I painted it with the kerosene and turned it a bit to wash it out good inside where I can't see. Lots of goo came out of there. I painted until it ran clean again. I'll pack it full of grease when I get that far. You all have to stay tuned in a week or two for part 2 of the continuing saga of 'Mr Ed the 319w before his time sewing machine'. I am fascinated by the engineering on the older zig zag machines. Each one is unique isn't it? I'm pretty sure I need to do something to the stitch length regulator - it doesn't travel.

I'm crossing my fingers that it NEVER happens Candice says it does. She posted earlier it was a b*tch to replace. You probably have to have the stars align up just so and hold your mouth a certain way and pray a whole bunch as you go. I sure don't want anything to get on it. The rubber belt not so much. I'm toying with the idea of treadling this one it does have a very nice table though.

I hope it doesn't wear out too quickly. It not something I relish looking for. But as for the rest of the workings just make sure you keep everything nicely lubricated and moist and you should be very happy.

I haven't got it yet so if all is well and works for a while I will cross that bridge when I get there. Want be the first time I bought something I had to fix. LOL If it does break does anyone know where to get a replacement? I read where you could not buy them anymore. Is that so? bannie

Is this about what a greece pot is for? Not heard of that before and now am concerned if I've cleaned my new vintage machines enough.

Actually, mine didn't wear out. I've got the original one. I made the stupid mistake of removing the gear it was on to try and clean the gear. Getting it back on was not fun at all! I don't recommend it:>

As for your stitch length regulator..lift it up and look inside the machine. Is the bar bent? When I was refurbishing my black 319, I noticed that my stitch length was really small and I couldn't get the 6 to 8 stitches per inch (basting length) even though my stitch length knob was all the way down. I fussed and kept playing with the feed dogs, I retimed it...nothing. Finally, I had an aha moment and looked up inside the machine. Somewhere in its travels it got bumped very hard and the bar was actually bent. I gently(and crossed my fingers not knowing if it would snap), hammered the bar upwards lightly a few times and straightened out the bar. This allowed it to lower all the way down to the 6-8 inch level and it's fixed now:> I think I like refurbishing these machines because they're big puzzle boxes!