Sewing Table made from Desk
#1
My neighbor threw out this desk, so I bought it home, drew around sewing machine, cut out the hole, took another board and cut to fit, then drilled 4 holes, put in 6 in 1/4" bolts with spacers made from small pieces of plastic tubing the length I needed for my sewing machine to sit down in. When the bolts were tightened, they could only go so far because of the spacers. When doing this you just have to make sure you have space to plug in your machine after you put it in place.
Now all I have to do is raise the back table 2 inches to be even.
Now all I have to do is raise the back table 2 inches to be even.
#7
There are actually 2 quilts on the back table. One is a baby quilt that I'm at the binding stage for my neighbor. I will take picture of it when done. The other is my buffalo quilt that I'm now working the sashings for it.
Thread
Thread Starter
Forum
Replies
Last Post