Don't Believe It
#1
Banned
Thread Starter
Join Date: Mar 2010
Location: Sturbridge, Ma
Posts: 3,992
I stopped by a sewing machine shop yesterday and they showed me the 1/4" seam foot for one of their machines.
Guess What? It didn't sew a true 1/4" seam. So be sure and check the foot and adjust to give you the correct seam. It won't make any difference if you are sewing squares but sure would make a difference if you are sewing mahy shapes together.
Guess What? It didn't sew a true 1/4" seam. So be sure and check the foot and adjust to give you the correct seam. It won't make any difference if you are sewing squares but sure would make a difference if you are sewing mahy shapes together.
#4
Power Poster
Join Date: May 2008
Location: MN
Posts: 24,666
If one has to move the needle setting to get a "1/4 inch" seam, why bother to get the 1/4 inch foot?
I used graph paper to figure out where to "set" my needle.
I lined up the right edge of the presser foot on one of the lines and fiddled with the needle setting until the needle came down on the next 1/4 inch line.
I used graph paper to figure out where to "set" my needle.
I lined up the right edge of the presser foot on one of the lines and fiddled with the needle setting until the needle came down on the next 1/4 inch line.
#5
Power Poster
Join Date: Jul 2008
Location: East Oklahoma - pining for Massachusetts
Posts: 10,477
Originally Posted by bearisgray
If one has to move the needle setting to get a "1/4 inch" seam, why bother to get the 1/4 inch foot?
I used graph paper to figure out where to "set" my needle.
I lined up the right edge of the presser foot on one of the lines and fiddled with the needle setting until the needle came down on the next 1/4 inch line.
I used graph paper to figure out where to "set" my needle.
I lined up the right edge of the presser foot on one of the lines and fiddled with the needle setting until the needle came down on the next 1/4 inch line.
#7
Super Member
Join Date: Jan 2010
Location: West Coast
Posts: 9,267
Originally Posted by Candace
On my janome 9000 you had to move the needle too. This is a very common thing. To get machines that do a hundred stitches, the needle may have to be moved over a hair. It's not a big deal, really.
#8
I know it sounds stupid but I have found this is to my advantage if I need a scant 1/4"
I can set it as per instructions for the 1/4" then move it slightly to the right.
much easier to me than trying to eyeball it
I can set it as per instructions for the 1/4" then move it slightly to the right.
much easier to me than trying to eyeball it
#9
I wonder if it is because each machine's center needle position is slightly varied?
When they machine all of the parts, it would be near impossible to get them all exactly identical.. as well as when the machines are assembled. :D:D:D
When they machine all of the parts, it would be near impossible to get them all exactly identical.. as well as when the machines are assembled. :D:D:D
#10
I had to move it quite a bit on my Janome 6600P to use the 1/4" foot (which I like because it has that little fence thing to run my fabric up against). On my MC3500 I only had to move it one click.
Thread
Thread Starter
Forum
Replies
Last Post
grann of 6
General Chit-Chat (non-quilting talk)
5
04-06-2011 10:57 AM
Butterflyspain
General Chit-Chat (non-quilting talk)
55
05-31-2010 07:53 PM