flying geese math
#1
Is there a way to figure the size square you need for the rectangle you are using? say the rectangle is 2x5. I know one side of smaller piece would be 2, what about the other side. Sorry, know this is kinda stupid question, but I am very math challenged. I want to place a row of flying geese along side a block and I can figure the size of rectangles I need to make it as long as the block but the other part is eluding me, especially when rectangle is not in exact inches.
#5
Try this method. She tells you how to get the size you want with no wasting fabric. I will keep looking the original way ..putting a square on two corners, sewing the diagonal and trimming to see if I can find one that shows how to calculate size too...
http://www.patchpieces.com/files/flyinggeese.pdf
also, if you read what she wrote at the top of that tutorial, she says:'just remember that the width of the finished unit is twice the height'
http://www.patchpieces.com/files/flyinggeese.pdf
also, if you read what she wrote at the top of that tutorial, she says:'just remember that the width of the finished unit is twice the height'
#6
And I found a site that makes them the traditional way. Altho I do 'square in the top two corners, sew on the diagonal, trim 1/4 inch and press' method too.
http://www.guidelines4quilting.com/H...locks/FG1.html
http://www.guidelines4quilting.com/H...locks/FG1.html
#7
and ONE more link! I think I'm done now...lolol
http://www.quilterscache.com/H/Howtomakegeese.html
This link has all THREE methods in one place...and you can make the size you want.
http://www.quilterscache.com/H/Howtomakegeese.html
This link has all THREE methods in one place...and you can make the size you want.
#9
Thank you all so much. I want to use the continuous flying geese method I just saw video tutorial for that someone posted tonight. Seemed like it would be easy but wanted to make them the size I wanted.
#10
Power Poster
Join Date: Mar 2009
Posts: 15,639
http://www.connectingthreads.com/tut...tars__D12.html
You have to cut each cross piece 1/4" bigger than to the center. Most of the time the size is based on a starting square. It makes the marking on the diagonal easier.
You have to cut each cross piece 1/4" bigger than to the center. Most of the time the size is based on a starting square. It makes the marking on the diagonal easier.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
12
07-24-2011 06:51 PM
craftybear
Links and Resources
6
04-19-2011 05:27 PM