Help!! Unpicking for 3rd time :(
#1
Member
Thread Starter
Join Date: Sep 2011
Posts: 10
So I'm still doing my daughters floor quilt/play mat and I've pieced the top, basted my layers and started stitching. 1st time I had my stitch settings wrong, as it's the first time using a walking foot, lesson learnt, so I unpicked and started again, it then puckered terribly on the top, so I unpicked and re basted, trimmed my boarders as I wasn't happy with the size while I was at it. Quilted again, and it's puckered badly again, I was very careful using safety pins to baste it was lovely and flat :(
I think my problem is I'm trying to do too large a pattern, I was just stitching in the ditch but my top only has 6 30x40cm rectangles, so the quilting was very far apart. I didn't want to do anything intricate because it's large and im inexperienced.
So my question is, should I be quilting a closer pattern? I have a darning foot so could do some free motion but I'm not 100% confident, but then again in still learning all aspects.
Any tips would be gratefully received as I sit and unpick the whole thing again, I could cry!!!
I think my problem is I'm trying to do too large a pattern, I was just stitching in the ditch but my top only has 6 30x40cm rectangles, so the quilting was very far apart. I didn't want to do anything intricate because it's large and im inexperienced.
So my question is, should I be quilting a closer pattern? I have a darning foot so could do some free motion but I'm not 100% confident, but then again in still learning all aspects.
Any tips would be gratefully received as I sit and unpick the whole thing again, I could cry!!!
#2
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
Look at the packaging for your batting (wadding?). It will tell you how far apart you can safely quilt.
When you pin the sandwich, you need to tape the backing down so that it is taut, but not stretched. Smooth your batting over, then the top and use lots of pins. You should not be able to put your fist down without touching pins. Then remove the tape. I would try SITD using your walking foot on a practice piece. It sounds to me as though the foot is not installed correctly. Check your owner's manual. There's either a prong or a fork thing-y that needs to go over or around the screw that holds the needle in. Again, work on a practice piece before trying it on your quilt. Don't be too discouraged, it's all part of the learning process.
When you pin the sandwich, you need to tape the backing down so that it is taut, but not stretched. Smooth your batting over, then the top and use lots of pins. You should not be able to put your fist down without touching pins. Then remove the tape. I would try SITD using your walking foot on a practice piece. It sounds to me as though the foot is not installed correctly. Check your owner's manual. There's either a prong or a fork thing-y that needs to go over or around the screw that holds the needle in. Again, work on a practice piece before trying it on your quilt. Don't be too discouraged, it's all part of the learning process.
#3
also don't use too small a stitch length. that too will cause puckers. you can stitch in the ditch and next go back and stitch 1/4 or 1/2 from all seams. and again inside that if necessary. simple stitching but looks nice and fills in where necessary.
#6
Power Poster
Join Date: Feb 2009
Location: Northern Michigan
Posts: 12,861
are you using a high loft batting? something like warm & natural which allows up to 10" between quilting lines is ideal to learn with-
some of the batts require 2" to 4" quilting (quite dense) and can be part of the problem- but too much loft can also be a problem- lofty batts are better used for tied quilts.
check the packaging and see what it says is recommended- try to lengthen your stitch length- often a longer stitch will keep your lines from puckering.
and slow down...trying to hurry the fabric through faster than the walking foot/feed dogs are going will also cause these problems
some of the batts require 2" to 4" quilting (quite dense) and can be part of the problem- but too much loft can also be a problem- lofty batts are better used for tied quilts.
check the packaging and see what it says is recommended- try to lengthen your stitch length- often a longer stitch will keep your lines from puckering.
and slow down...trying to hurry the fabric through faster than the walking foot/feed dogs are going will also cause these problems
#7
Power Poster
Join Date: Mar 2009
Posts: 15,639
When I put my sandwich together I make sure that the backing is quite taut (but not overstretched). Then I smooth the batting and pat down the top until it is also taut. I pin about hand-width apart. Have not had problems.
I believe that your SIDs are too far apart, but you can add lines inbetween. Odds are, your stitches were a little too tiny and the poor foot had trouble keeping up. I set my stitch length to 3 or 3.5 (Compared to 2 or 2.5 for piecing)
Good luck. You are way more patient than I would be. If my quilt wants to misbehave twice, it stays the way it is puckers and all.
I believe that your SIDs are too far apart, but you can add lines inbetween. Odds are, your stitches were a little too tiny and the poor foot had trouble keeping up. I set my stitch length to 3 or 3.5 (Compared to 2 or 2.5 for piecing)
Good luck. You are way more patient than I would be. If my quilt wants to misbehave twice, it stays the way it is puckers and all.
#8
Super Member
Join Date: Apr 2007
Location: Alturas, CA
Posts: 9,393
If you don't have a deadline for the quilt, I would set it aside and work on something else for a while, it seems that sometimes things just don't want to be made. Quilting is supposed to be relaxing not stressful.
Thread
Thread Starter
Forum
Replies
Last Post
Susan7639
Main
7
09-18-2015 07:09 PM