How do you stop and start your quilting?
#1
How do you stop and start your quilting?
I have been concerned with the way I end my quilting. I have a Brother machine and it has it so I can have it cut the threads. Does some kind of knot first. Then I just cut the leftover thread ...
Do I need to tie them and hide each one in quilt?
Sometimes I am starting and stopping in each block or just different places to do different designs.
Would love new ideas on this...
Thanks in advance for your feedback..
Darlene
Do I need to tie them and hide each one in quilt?
Sometimes I am starting and stopping in each block or just different places to do different designs.
Would love new ideas on this...
Thanks in advance for your feedback..
Darlene
#2
Power Poster
Join Date: Mar 2011
Location: Ontario, Canada
Posts: 41,548
I knot my threads and use an easy thread needle to bury them in the sandwich. Yes, it is a lot of work but I prefer the look. I do them a section at a time because it is a real PAIN if you leave them all to do at the end of your quilt.
#3
Senior Member
Join Date: Apr 2011
Location: Ohio
Posts: 952
I knot my threads, leaving about 3 inches of thread, after I take the quilt off the machine and use a needle with the slot in the top to slide the two threads and then bury them. If I finish sewing on the side of the quilt or and edge, I will do two stitches back to lock then I don't have to bury the threads, just clip them off.
#5
Super Member
Join Date: Oct 2010
Location: Fox Valley Wisconsin
Posts: 1,920
I take several very short stitches (3-4) and then cut the threads off. Have never had a seam undone. If I was going to make a quilt for a competition, then I would bury the threads.
Unfortunately, most machines that have a "locking stitch" only stitch in the same place, and if you cut that off, you lose the locking, that is why I use the several short stitches.
Unfortunately, most machines that have a "locking stitch" only stitch in the same place, and if you cut that off, you lose the locking, that is why I use the several short stitches.
#6
Super Member
Join Date: Aug 2010
Location: Piedmont Virginia in the Foothills of the Blue Ridge Mtns.
Posts: 8,562
I agree with Patchsamkim. I dial my stitch length down to between 0-1, take 4-5 stitches, then roll the dial to 3-4, cut the thread ends. after doing this for several lengths of stitching, it will become more natural to use your right hand to change the stitch length without moving your left hand holding the quilt in place. I use a mechanical (non-computerized) Bernina 1031 mostly.
Jan in VA
Jan in VA
#9
I agree with Patchsamkim. I dial my stitch length down to between 0-1, take 4-5 stitches, then roll the dial to 3-4, cut the thread ends. after doing this for several lengths of stitching, it will become more natural to use your right hand to change the stitch length without moving your left hand holding the quilt in place. I use a mechanical (non-computerized) Bernina 1031 mostly.
Jan in VA
Jan in VA
Thread
Thread Starter
Forum
Replies
Last Post
nanna-up-north
For Vintage & Antique Machine Enthusiasts
13
10-28-2013 12:53 PM
lisalisa
General Chit-Chat (non-quilting talk)
54
02-19-2011 11:01 AM