Just wondering about tension....
#1
Just wondering about tension....
Is it possible that "the right" tension for your machine can be different depending on whether you are piecing 2 pieces of fabric together or if you are walking foot quilting through fabric and batting? I have my bobbin tension set quite loose but am getting nice, unpuckered straight line quilting with even stitches on both sides. I have just read an article that says to set perfect tension you should sew on the bias across two 5" squares of fabric and then pull at each corner where you started and stopped sewing until the threads break. The top thread and the bottom thread should both break at the same place indicating good tension. When I do this my top thread breaks but the bottom doesn't....I'm guessing because it is set at a loose tension. But my stitching on the quilt looks good....so do I have bad tension despite it looking ok?
#2
Super Member
Join Date: Nov 2010
Location: Utah
Posts: 2,093
I'd keep it where it looks good to you.
At the shop, we use a different method. We set the machine to do a zig-zag stitch, with dark thread on top and light thread in the bobbin (cotton thread). Then, we want the top thread to just "tick" to the back side. Then when you go to sew a straight stitch it's usually right where it should be.
I do set my tension differently for different applications. That's why they made our tensions adjustable.
At the shop, we use a different method. We set the machine to do a zig-zag stitch, with dark thread on top and light thread in the bobbin (cotton thread). Then, we want the top thread to just "tick" to the back side. Then when you go to sew a straight stitch it's usually right where it should be.
I do set my tension differently for different applications. That's why they made our tensions adjustable.
#5
Power Poster
Join Date: Jan 2011
Location: Southern USA
Posts: 16,426
Thread type and size and needle type and size are important for tension too. Lot of factors come into play. I usually start with 0 and go up until the stitches look like I want them to look when I change the amount of fabric, needle type or thread type. I keep a notebook handy to write the tension setting for each configuration. It saves me a lot of time as I usually use the same ones
#7
Power Poster
Join Date: Nov 2009
Location: Mableton, GA
Posts: 11,334
#8
Power Poster
Join Date: Jan 2011
Location: Southern USA
Posts: 16,426
I have the Brother 1500 too and I have to change the tension for the thread type to match the pressure from the foot. I had a tech explain that to me as the color coding is the silliest thing on that machine. But it is one of the best machines I have and so easy to have repaired if needed.
Thread
Thread Starter
Forum
Replies
Last Post