Manual for a Singer Creative Touch 1036
#1
Junior Member
Thread Starter
Join Date: Dec 2010
Posts: 189
Manual for a Singer Creative Touch 1036
Does anyone know of a source for a free downloadable manual for this sewing machine? I bought one today at an Estate Sale. It sews a beautiful stitch, but, I think it could use some oil, it is kinda loud.
#2
Senior Member
Join Date: Aug 2012
Posts: 786
I have no idea where you can download a free manual but I have a 1036. The machine does run on the loud side even when it was brand new. When I notice it's a bit louder than usual, I know it's time for a good cleaning. There are no instructions on how to oil the machine in the manual. I've kept mine running by doing the following steps. First I clean as much lint as I can from the top of the machine. Slide open the slide plate and remove the needle plate so you can clean the feed dogs and all around the bobbin case. Put everything back together and now clean from the underside of the machine. You will need a tube of Singer Lubricant grease http://www.singeronline.com/lubricantgease.html. Remove the plastic base cover. You will notice two gears directly below the bobbin case. They will be covered with lubricant and lint. I clean them with a lint brush and reapply grease. I do the same to the other gears as well. Any spots that have metal to metal contact I oil with sewing machine oil.
#3
Member
Join Date: Jul 2013
Posts: 1
http://www.singerco.com/uploads/down...41dc3cb14f.pdf
It is for model 1030 which is very similar to the 1036. I found the Parts Manual for the machine and this same manual applies to both models so they must be very similar. If you want this manual, it can be found here:
http://www.manualslib.com/manual/153...ger-1036e.html
You can also purchase a Product Manual for the 1036 from Singer's website for $15. I did not purchase it so I don't know how it compares to the free document above (which was sufficient for my needs).
#6
I still have my Singer 1036 but haven't used it in many years. It seems like I did put a drop of machine oil on a hole under the bobbin. I know I do in my Janome. it is a wick in that hole. otherwise I always let the repairman do what ever it required. I do have my manual somewhere too.
Thread
Thread Starter
Forum
Replies
Last Post
janiesews
For Vintage & Antique Machine Enthusiasts
2
06-17-2013 11:38 AM
PTM
For Vintage & Antique Machine Enthusiasts
0
11-10-2011 02:02 PM