Panels
#1
Panels
When using a panel, how do you trim around the panel and make sure your cut is straight when the panel is 46" long? I'm going to be adding other blocks with it but I'm afraid I won't get the panel cut correctly. How is this done?
Clear as mud?
Thanks
Clear as mud?
Thanks
#3
I guess you are talking about a printed design on a piece of fabric ? I just made some quilts that had panels and I had to cut each one of the panels out separately mainly because they were not really even. I would definitely not assume they are even and use your rulers without seeing the entire panel. I have even used my scissors on smaller panels, to cut them as perfect as I can. I hope this answers your question.
#4
I open the panel up, lay it on the cutting mat and put the ruler against the border line or edge of the design with a 1/4 inch over for the seam allowance so when I sew a border on, it lines up correctly.
#7
I have used panels & pillow tops that are preprinted. Older ones were true to grain. Newer ones are NOT. size doesn't matter. Before cutting straighten old fashioned wAY-- 2 people, each holding corner of cut edge, puu with both right hands (diagnol) then with other hand doesnt always work, but usually helps some.
LQS owner says distortion happens when fabric is wound on boards.
LQS owner says distortion happens when fabric is wound on boards.
#8
Power Poster
Join Date: Mar 2009
Posts: 15,639
After I press the panel, I use my large square and my long ruler to see where the cut would fall. Sometimes I simply pick a line and stick to it. If the panel is printed crooked there is no straightening. Putting a pieced border on it that draws attention away from the crookedness is always a good idea.
#9
Super Member
Join Date: Nov 2010
Location: Cadillac, MI
Posts: 6,487
Wash and press the fabric to remove the manufacturer stretching, then cut it scissors. Now you can pull on the diagonal to straighten it. If all of this doesn't work, adjust the width of your borders. I've only done 22" squares, but it worked.
#10
Thread
Thread Starter
Forum
Replies
Last Post