Revitalizing Seam Fix seam ripper
#1
Junior Member
Thread Starter
Join Date: Jan 2013
Location: Madison, WI
Posts: 187
Revitalizing Seam Fix seam ripper
I really like my seam fix seam ripper, but the nubby top has gotten hard and smooth, and won’t grab thread bits like it used to. Does anyone know of a way to revitalize it?
#2
Power Poster
Join Date: Jan 2008
Location: Florida
Posts: 17,636
sounds like the moisture went out of it. I think ppl might be afraid to
reply bc if it get messed up they don't want it to be their fault,
it could be you just posted and they haven't had time to think of
anything .
I'd go with the moisture thing and see if sitting in a glass of water
with only a half inch maybe, and see what that does.
It might be old and have arthritis, then there's no cure yet.
reply bc if it get messed up they don't want it to be their fault,
it could be you just posted and they haven't had time to think of
anything .
I'd go with the moisture thing and see if sitting in a glass of water
with only a half inch maybe, and see what that does.
It might be old and have arthritis, then there's no cure yet.
Last edited by QuiltnNan; 10-15-2019 at 05:43 PM. Reason: shouting/all caps
#3
Super Member
Join Date: Jan 2012
Posts: 4,783
Sounds to me like a pencil eraser that gets hard and won't erase. If soaking in water doesn't work, I'd try coating it with rubber cement and letting that dry, or taking a sharp pen knife to it and cutting away a layer all around, because I'd figure I have nothing to lose, it already doesn't work. And I'd probably replace it no matter if that worked or not, because I have about a dozen seam rippers all over the house, lol.
#4
Power Poster
Join Date: Apr 2011
Location: Ontario, Canada
Posts: 17,827
My thoughts are that maybe the rubber part has got coated with all the grunge of the scrubbing.
And that maybe if it were scrubbed up a bit with something rough ...
...like maybe one of those green kitchen nylon scrubbies to help get it back to life?
Good Luck!
However ... maybe this is a question to ask the manufacturer?
If it's happened to you .... it has probably happened to others before,
so they should have answers for you.
And that maybe if it were scrubbed up a bit with something rough ...
...like maybe one of those green kitchen nylon scrubbies to help get it back to life?
Good Luck!
However ... maybe this is a question to ask the manufacturer?
If it's happened to you .... it has probably happened to others before,
so they should have answers for you.
#8
Super Member
Join Date: May 2012
Location: Central Wisconsin
Posts: 4,391
#10
I have one of those white erasers that I keep as my thread grabber. I can go right down the ripped seam and it clean things up really fast.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
2
06-14-2010 10:02 PM