securing 1/4" ribbon--what stitch?
#1
Super Member
Thread Starter
Join Date: Nov 2007
Posts: 9,688
The present project--well--one of them--requires that I attach 1/4" ribbon to the wall hanging. I'm wondering just what is the best stitch to use to not tear it up. One straigth stitch down the middle? A straight stitch on either side? Perhaps a zigzag? I'm open to suggestions from those who have been in this place. :-D
I'm thinking about using the 1/4" Steam-a-Seam to help hold it in place--but it'd have to be together perfectly; I don't know if I should risk it.
I'm thinking about using the 1/4" Steam-a-Seam to help hold it in place--but it'd have to be together perfectly; I don't know if I should risk it.
#2
A few tiny dabs of Elmers and heat set with the iron may work... I would try it on a scrap first :wink:
A decorative stitch just a tad wider than the ribbon would be cute too. A more open stitch, you can even elongate it, so the ribbon shows through :D:D:D
A decorative stitch just a tad wider than the ribbon would be cute too. A more open stitch, you can even elongate it, so the ribbon shows through :D:D:D
#4
Super Member
Join Date: Jan 2008
Location: currently central new jersey
Posts: 8,623
what is the ribbon for? is it the loop that you use to hang it from? or part of the design? for the design, i would put down tiny dots of washable glue to keep it in place. let that dry well. zig zag or straight stitch really small on the edges. imo, if you do one row of stitching down the center, the sides will flare up and not look so good. if it's to make loops, i would fold back on itself and cover with a small button r applique.
#7
Super Member
Thread Starter
Join Date: Nov 2007
Posts: 9,688
Ooo--good ideas everyone!! Thanks!! The ribbon is part of the design. I can't show it yet because I'm making one for a person who reads this board now and then.... it's a secret. :wink:
I have all these fancy stitches on my machine--I think this is a good opportunity to use one!!
I have all these fancy stitches on my machine--I think this is a good opportunity to use one!!
Thread
Thread Starter
Forum
Replies
Last Post
Sarabela
For Vintage & Antique Machine Enthusiasts
25
11-25-2014 05:33 AM