Spray Adhesive
#1
Member
Thread Starter
Join Date: Jan 2013
Posts: 6
Spray Adhesive
I have a can staring at me and afraid to use it. Can someone give me some tips, advice, advantages, or comments about using this in my quilting. Will I make a mess of everything around me when I spray it?
#2
Super Member
Join Date: Aug 2009
Location: The middle of an IL cornfield
Posts: 7,014
I have found the overspray to be minimal. I try to spray from the outside toward the middle as much as possible. Spray one half at a time and smooth it down.
I have wood floors and the overspray just mops up off of it with no problem. It encourages me to mop! I have never had a problem with gumming up needles or anything. It works great for me.
I have wood floors and the overspray just mops up off of it with no problem. It encourages me to mop! I have never had a problem with gumming up needles or anything. It works great for me.
#3
Super Member
Join Date: Apr 2010
Location: Illinois
Posts: 9,312
Do you have spray adhesive or spray basting? If its is spray basting what type /manufacture ? Some perform differently than others.
There is a good amount of over spray.. so spread sheets or papers around the area. I usually go at least 18 inches past the edge of the item I am quilting with protection. Usually less is better and lightly spray the item. I know when did my first I used way too much as it just did not seem to be sticky .. but it was. Sometimes it does not get tacky right away. I still pin the outter perimeter , as sometimes the edges will lift in the handling and quilting process. I suggest a small sample 12 -18 inches square so you can get a feel for the nature of spray basting , you can judge how much you you really need and it will help get you past the "first time jitters".
There is a good amount of over spray.. so spread sheets or papers around the area. I usually go at least 18 inches past the edge of the item I am quilting with protection. Usually less is better and lightly spray the item. I know when did my first I used way too much as it just did not seem to be sticky .. but it was. Sometimes it does not get tacky right away. I still pin the outter perimeter , as sometimes the edges will lift in the handling and quilting process. I suggest a small sample 12 -18 inches square so you can get a feel for the nature of spray basting , you can judge how much you you really need and it will help get you past the "first time jitters".
#6
so far i've done my quilts on my folding JoAnn's table. I center my backing then batting, then top. lift (or now I roll up) my top several times, then spray with Sulky or 505 and fold down or roll down the top to cover, then spray and on and on. then i flip it all over and do the backing.
now i usually spray the batting although some "rules" somewhere says to spray the fabric only. i just know i've never had a problem doing it my way.
now i usually spray the batting although some "rules" somewhere says to spray the fabric only. i just know i've never had a problem doing it my way.
#7
Super Member
Join Date: May 2011
Location: Pacific NW
Posts: 9,563
First and foremost, check the label and make sure it's washable. Also, do a practice sandwich and see how it behaves in your machine. I've never had a problem, but others have complained of some products gumming up their needle.
#8
http://www.sulky.com/adhesives/index_adhesives.php I think I'd do a little more research on the "temporary" part, unless you're able to spray it & quilt it all in the one day.
Thread
Thread Starter
Forum
Replies
Last Post