Square up tool
#13
So do you put the corner of the square ruler on the corner of your block? What if you see your block is not square? Won't whacking off the block to make it square cause your block to end up too small? I too think I need a tutorial on this subject.
#17
Power Poster
Join Date: Mar 2009
Posts: 15,639
Originally Posted by Granny Coy
So do you put the corner of the square ruler on the corner of your block? What if you see your block is not square? Won't whacking off the block to make it square cause your block to end up too small? I too think I need a tutorial on this subject.
I usually measure my blocks to see what size range I am dealing with. Then I see if I can block the smaller ones to be the correct size. There is a little play allowed (if you listen to Eleanor Burns, I think she allows 1/8" which can be adjusted).
To block, I spray the block lightly with starch and/or steam press it into shape. I pin it to the ironing board and let it dry. That has never let me down, BUT I never try to "fix" large discrepancies.
When the block is too large, I see if any points will be lost if I cut it down. If I have no HSTs along the edge, I may just cut it to fit. Some blocks are easier to trim than others and a lot depends on how they would look next to the neighbor block.
#18
Originally Posted by MadQuilter
Originally Posted by Granny Coy
So do you put the corner of the square ruler on the corner of your block? What if you see your block is not square? Won't whacking off the block to make it square cause your block to end up too small? I too think I need a tutorial on this subject.
I usually measure my blocks to see what size range I am dealing with. Then I see if I can block the smaller ones to be the correct size. There is a little play allowed (if you listen to Eleanor Burns, I think she allows 1/8" which can be adjusted).
To block, I spray the block lightly with starch and/or steam press it into shape. I pin it to the ironing board and let it dry. That has never let me down, BUT I never try to "fix" large discrepancies.
When the block is too large, I see if any points will be lost if I cut it down. If I have no HSTs along the edge, I may just cut it to fit. Some blocks are easier to trim than others and a lot depends on how they would look next to the neighbor block.
If it's just a matter of the block being too big you trim it off into a square, unless you have HSTs on the edge. What is an HST? If you have one of those I suppose you chuck the whole thing and just make a new block taking more care to get this one straight to start with. I sure hope I have extra fabric in the right prints if that happens.
I appreciate your help to understand this. Can I use the square up ruler to make sure my blocks are square when I cut them? I am using a 3x18" clear ruler, a cutting mat that is slightly larger, and a rotary cutter.
#19
Originally Posted by grammysews4u
I wish someone that really knows how to use it right would do a tut on squaring up. Never was taught how to use all the lines and degrees
#20
well walmart ahs june tailor square rulers for 26 its a set of four; a 12, a 9, a 6, and a 4 inch. they do have a blue edge that adds a fourth inch to each side. so you dont have to measure for seem allowence.
Thread
Thread Starter
Forum
Replies
Last Post
nativetexan
Main
28
10-19-2013 08:37 PM