Starting & Stopping When Quilting - How?
#1
When using your machine to quilt, how do you start and stop?
I've look but haven't found clear information on what to do with the thread that dangles off the front and the back.
Any guidance would be greatly appreciated!
I should say I am using my sewing machine, no hand quilting here. God bless those with that much patience.
I've look but haven't found clear information on what to do with the thread that dangles off the front and the back.
Any guidance would be greatly appreciated!
I should say I am using my sewing machine, no hand quilting here. God bless those with that much patience.
#2
Senior Member
Join Date: Nov 2008
Location: Pacific NW USA
Posts: 883
I pull the bobbin thread up from behind first. Do that by putting the needle down into the fabric once, then bring the needle up and pause and pull the top and bottom threads up and out to the side. At that point where they come out of the fabric, have the machine do a couple very small stitches to lock everything, then trim the thread tails close to the fabric and then a start free motion.
#3
If I'm piecing, I just start at one end of the piece and end at the other, no backstitching required since I will be sewing over those starting and ending points with other seams that will anchor them. When machine quilting, I do backstitch the start and ends since those will not be stitched over (they will be stitched by). So the rule of thumb is that if you are going to eventually stitch over the start or end of the thread, I don't think there's a need to anchor the start or end with a backstitch.
Ooops, I just reread your post, you are talking about quilting, not piecing. So I always backstitch to start and stop quilting.
Ooops, I just reread your post, you are talking about quilting, not piecing. So I always backstitch to start and stop quilting.
#5
Originally Posted by AtHomeSewing
I pull the bobbin thread up from behind first. Do that by putting the needle down into the fabric once, then bring the needle up and pause and pull the top and bottom threads up and out to the side. At that point where they come out of the fabric, have the machine do a couple very small stitches to lock everything, then trim the thread tails close to the fabric and then a start free motion.
Dallas news girl: Thank you for asking this question.
Linda
#8
Banned
Join Date: Apr 2009
Location: Sleepy Hollow, NY
Posts: 4,727
i pull the bobbin thread to the top. i take a few small stitches very close together to lock the threads and then i start normal paced quilting.
i do the exact same thing to end.
i try to start and stop in a place that isn't too noticeable.
when i'm all done a thread any tails into a needle and pull it into the sandwich.
i do the exact same thing to end.
i try to start and stop in a place that isn't too noticeable.
when i'm all done a thread any tails into a needle and pull it into the sandwich.
#9
Have you heard of burying the knot? You pull up the bobbin thread, keep both top bottom thread long enough to tie a knot very clost to the fabric. Then, you thread a sewing needle, place the needle between the fabrics, pull it out fairly close to the knot then yank on the thread until you hear the knot pop into the fabric, between the layers. I hope this is clear.
Thread
Thread Starter
Forum
Replies
Last Post
frannella
Main
10
11-03-2019 06:30 AM
MathTeacher1980
Main
9
08-15-2012 01:43 PM