Texture Magic? Chart for cutting fabric
#1
Senior Member
Thread Starter
Join Date: Aug 2008
Posts: 844
I just bought some texture magic but wasn't sure how large I should cut my fabric to make up for the shrinkage.
Here's a link I found in case you were wondering also--
http://www.superiorthreads.com/media...t_Single_3.JPG
Here's a link I found in case you were wondering also--
http://www.superiorthreads.com/media...t_Single_3.JPG
#2
Super Member
Join Date: Apr 2010
Location: Illinois
Posts: 9,312
Use the texture magic with the batting and fabric the same size. ( not sure if I am explaining this properly) The finished "piece" ( fabric , batting, and fabric) or unit will be approx 25-30 percent smaller. The demonstration I saw said to be safe use more like 22 percent smaller. It will shrink in all directions. So if you need a 10 square you need 13 inches of all , fabric, batting and texture magic. this is figuring ruffly 30 percent.
Different fabrics will react differently , as will the batting ( if used ) will affect the final diminsions.
Take the lenght of the desired finished piece and mulitlply by 1.30 then take the width and do the same. These are your new starting dimensions.
I have been using 25 percent with most of my fabrics and so far so good . I have a feeling I may get a bad surprise some day. Its so expensive I just do not want to waste and inch.
Different fabrics will react differently , as will the batting ( if used ) will affect the final diminsions.
Take the lenght of the desired finished piece and mulitlply by 1.30 then take the width and do the same. These are your new starting dimensions.
I have been using 25 percent with most of my fabrics and so far so good . I have a feeling I may get a bad surprise some day. Its so expensive I just do not want to waste and inch.
#3
Banned
Join Date: Jun 2010
Location: Washington State
Posts: 1,312
I believe it also depends on how much sewing you do on your texture magic before you shrink it. I played around with it before I made a purse with it and it does make a difference on how much stitching you put on it first.
Thread
Thread Starter
Forum
Replies
Last Post