Ugh! My machine makes the worst birdnests. What can I do?
#1
Member
Thread Starter
Join Date: May 2013
Posts: 94
Ugh! My machine makes the worst birdnests. What can I do?
Is there an easy way to get rid of birdnests? I've tried adjusting the tension and making sure the thread was taught before starting a stitch but I still get them. Any tips?
#4
Some machines just 'do' this. Try using a leader (I call them thread bunnies). Fold a three inch square scrap into three lengthwise so that it is three inches long and about an inch wide, run this under the needle first and then lead on to your sewing. You can also use them as enders and save thread when you are chain piecing. I use them all the time.
#5
Super Member
Join Date: May 2012
Location: S.E. Queensland, Australia
Posts: 1,489
Check that your top thread is threaded properly through the tension discs, and the same with the bobbin thread. If you can pull the thread through the needle while the foot is down, it's probably not threaded correctly, or the discs need tightening. Take off the plate below the foot and clean away all fluff from inside and outside the bobbin casing.
#6
For me, the problem is always the top thread is being pulled down into the bobbin area. These are my only solutions. Hope they help.
First, hold your top and bottom threads down against the throat plate when you take the first couple of stitches. This prevents the top thread from being drawn down into the bobbin area:
[ATTACH=CONFIG]425631[/ATTACH]
Next, use a "leader/ender" from there on out. A scrap of fabric. Just run it under the machine when you're ready to take your quilt pieces off the machine. That's your "ender". Leave it on the machine.
[ATTACH=CONFIG]425632[/ATTACH]
When you start sewing again, it will become your "leader" and you won't get nests. As you can tell, mine is well loved and well used. I've got about a dozen of these floating around my sewing machine. Saves thread - and the headaches of thread nests!
First, hold your top and bottom threads down against the throat plate when you take the first couple of stitches. This prevents the top thread from being drawn down into the bobbin area:
[ATTACH=CONFIG]425631[/ATTACH]
Next, use a "leader/ender" from there on out. A scrap of fabric. Just run it under the machine when you're ready to take your quilt pieces off the machine. That's your "ender". Leave it on the machine.
[ATTACH=CONFIG]425632[/ATTACH]
When you start sewing again, it will become your "leader" and you won't get nests. As you can tell, mine is well loved and well used. I've got about a dozen of these floating around my sewing machine. Saves thread - and the headaches of thread nests!
Last edited by cindi; 07-24-2013 at 02:37 AM.
#7
sometimes there is a piece of thread or dust caught between the tension discs. when this happens, no amount of tension adjusting is going to help. take the tension disc assembly apart if possible and clean it thoroughly.
#10
are you doing straight stitches or trying Free Motion Quilting? you didn't say. usually bird nests come with doing FMQ and not bringing the bobbin thread to the top and holding both threads for a few stitches. I hope you've solved your problems and are going strong now!
Thread
Thread Starter
Forum
Replies
Last Post
Chasing Hawk
General Chit-Chat (non-quilting talk)
22
06-16-2013 10:20 PM
quiltinghere
For Vintage & Antique Machine Enthusiasts
10
12-06-2010 05:57 PM
ArtisticDesign
Main
7
10-29-2010 05:07 PM