Hi All! Newbie looking for some assisance
#1
Member
Thread Starter
Join Date: May 2013
Posts: 1
Hi All! Newbie looking for some assisance
Hey everyone, I just made an account here today and am super excited putting my machine to proper use-except I'm entirely new to this and can't seem to get the machine to stitch.
http://imgur.com/HKtmNyq
Thats picture of the machine, I've figured out how to wind the bobbins and load the bobbin into the shuttle. I'm not 100% on how to thread the machine and as a result (I think) the machine wont stitch at all
Anyways, any insight would be greatly appreciated as I lost and I can upload pictures if needed
http://imgur.com/HKtmNyq
Thats picture of the machine, I've figured out how to wind the bobbins and load the bobbin into the shuttle. I'm not 100% on how to thread the machine and as a result (I think) the machine wont stitch at all
Anyways, any insight would be greatly appreciated as I lost and I can upload pictures if needed
Last edited by socta189; 05-13-2013 at 03:04 PM.
#2
Senior Member
Join Date: Feb 2013
Location: 1000 miles from nowwhere
Posts: 671
the thread should go into a guide ----then through the tension knob -----to the thing that goes up and down ...has hole to some more guide then to the needle ....hope that makes sense and helps
#3
Super Member
Join Date: Aug 2011
Location: Millville, NJ
Posts: 1,835
Hi,
You can make out the thread path from this picture and order a manual if needed:
http://www.tias.com/173/PictPage/1922476954.html
Hopefully you have a supply of needles on hand or one to measure as it appears to be a non standard size according to ismacs needle list. Good luck with your project.
Jon
You can make out the thread path from this picture and order a manual if needed:
http://www.tias.com/173/PictPage/1922476954.html
Hopefully you have a supply of needles on hand or one to measure as it appears to be a non standard size according to ismacs needle list. Good luck with your project.
Jon
Thread
Thread Starter
Forum
Replies
Last Post
Annaquilts
Pictures
60
09-27-2015 10:16 AM
cmputerdazed
Links and Resources
11
03-16-2011 01:38 PM