1/4 inch foot for featherweight
#13
Super Member
Join Date: Jan 2010
Location: Outer Space
Posts: 9,319
#14
Senior Member
Join Date: Jan 2011
Location: Northwestern Lower Michigan/Seminole, Florida
Posts: 372
#15
Super Member
Join Date: May 2010
Location: Round Rock,Texas
Posts: 6,135
I use that foot on all my Singer low shank machines, also have one for my 301. Its a nice foot, can even use it on my Singer 237. I take the metal guide bar off the foot and like it much better.
Sharon W.
Sharon W.
#17
Member
Join Date: Apr 2012
Posts: 21
I bought mine at Hancock Fabrics for my FW. Be sure to pay attention because it comes in a slant shank and a short shank. You want the short (straight) shank. It has a metal piece on it that you can butt your fabric against when sewing. It is a generic foot. If you have a coupon it can save you some money.
#18
Member
Join Date: Nov 2011
Location: California girl
Posts: 67
Oh THE very best 1/4" is one of the lowest priced ones. I have used the Apha foot, and other ones "they" say are good but they never held the fabric well.
I found that if you go and find a White low shank 1/4" foot it is the best and when I bought them they were only like $6 ea.
Don't waste your money on those hig cost ones..I know I have bought them all.
I found that if you go and find a White low shank 1/4" foot it is the best and when I bought them they were only like $6 ea.
Don't waste your money on those hig cost ones..I know I have bought them all.
Thread
Thread Starter
Forum
Replies
Last Post