Hi All! Newbie looking for some assisance

Reply Subscribe

Page 1 of 2

Thread Tools

05-13-2013, 03:00 PM

socta189

Member

Thread Starter

Join Date: May 2013

Posts: 1

Hi All! Newbie looking for some assisance

Hey everyone, I just made an account here today and am super excited putting my machine to proper use-except I'm entirely new to this and can't seem to get the machine to stitch.

http://imgur.com/HKtmNyq
Thats picture of the machine, I've figured out how to wind the bobbins and load the bobbin into the shuttle. I'm not 100% on how to thread the machine and as a result (I think) the machine wont stitch at all

Anyways, any insight would be greatly appreciated as I lost and I can upload pictures if needed

Last edited by socta189; 05-13-2013 at 03:04 PM.

05-13-2013, 03:12 PM

yel

Senior Member

Join Date: Feb 2013

Location: 1000 miles from nowwhere

Posts: 671

the thread should go into a guide ----then through the tension knob -----to the thing that goes up and down ...has hole to some more guide then to the needle ....hope that makes sense and helps

05-13-2013, 04:50 PM

jlhmnj

Super Member

Join Date: Aug 2011

Location: Millville, NJ

Posts: 1,835

Hi,

You can make out the thread path from this picture and order a manual if needed:

http://www.tias.com/173/PictPage/1922476954.html

Hopefully you have a supply of needles on hand or one to measure as it appears to be a non standard size according to ismacs needle list. Good luck with your project.

Jon