Project machine
#1
Senior Member
Thread Starter
Join Date: Apr 2009
Posts: 609
Project machine
I've got an old Singer with super stuck parts. I've been spraying PB Blaster in it every week but its still stuck. It's supposed to be 90 today and tomorrow so I'm going to set it in the sun to see if maybe the heat will free it up. If this doesn't work is it possible to take the thing apart, clean all the rust off, put it back together and have it work? When I say take a apart I mean the inner rods and such. The machine is a 1910 model and there really doesn't look to be too much involved. Any suggestions.
#2
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
i have 2 super stuck machines, too. Mizkaki has recommended Kroil oil like you would use oil, careful of the paint and heat. Turn it every direction and turn the hand wheel. On mine the bottom moves freely for reverse and free motion. We are thinking the stuck part is the needle bar. I took apart the pressure bar - it had some kind of bad dried up oil in there. Once cleaned it works fine. I assume the needle bar has the same. I haven't found a local source of Kroil yet. It is on my to do list. I have two machines stuck. Mizkaki says when they are like that it is usually the needle bar.
#3
Senior Member
Thread Starter
Join Date: Apr 2009
Posts: 609
This one has been stuck since I got it, about 6 months ago. The hand wheel will not turn and the needle bar and tension thingy seems to be free of rust. The insides are another story. I tipped the machine on its face plate(removed) and sprayed PB Blaster into the center cavity. It didn't drain down so theres a clog in the middle. If this doesn't do it I'm going to pour evaporust in and see if that will do anything. After all that, if its still stuck I'm going to start removing rods and such till I get it freed up. I'll take pictures of each step so I know how to put the thing back together.
#5
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
The evap-o-rust could do more harm than good - don't use it. Wait a couple days until Cathy and I can put up some kind of tutorial. I have two to try to fix. Maybe Joe or someone will have good info, too.
#7
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
I'm remembering why I haven't got any of it yet... I'm not having any luck finding it locally - here is what I did find:
http://www.ebay.com/itm/like/351050368356
http://www.ebay.com/itm/like/351050368356
#9
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
#10
Power Poster
Join Date: Mar 2011
Location: Somewhere
Posts: 15,506
http://www.kanolabs.com/google/ at the top of the page is a google deal - you really have to want a lot of it but it is a better deal than anything else I could find. I could not find it locally. I'll start something when it gets here. I have two machines to test it on. I hope it doesn't take all of it...
Thread
Thread Starter
Forum
Replies
Last Post
NOELLA
General Chit-Chat (non-quilting talk)
18
02-27-2013 08:32 AM
lovetosewstudio
Links and Resources
47
08-10-2011 04:29 AM
roselady
Main
14
11-18-2010 05:07 AM