MacSkyver

There are several reasons why I would do the project. First off, it was super fun figuring everything out. The machine has sentimental value as it was my first sewing machine and has been in my family for many years. Also, the table should be fairly universal, so I could replace this machine with many other machines if I so choose.

From a cost standpoint, it wasn't super expensive. I needed a table anyways and buying a decent one would be a couple hundred dollars by itself. I could potentially find a good used vintage one on Craigslist, but I tried that and didn't find anything good/reasonably priced. For this table, the plywood for the top cost me around $40 and I had the steel and aluminum laying around. The hardware from McMaster was around $100. The servo motor from Amazon was $105.

So basically for around $250 and a little time, I ended up with a super robust ergonomic setup I built with my own two hands that will last for generations whilst having fun in the process.

MacSkyver

When I got the sewing machine, it was in an old New Home carrying case. It had hinges which worked fine, so I used them. Here is a picture I found online that looks identical to the ones I used:

[ATTACH=CONFIG]609446[/ATTACH]

If you look at my earlier picture of the drip tray, you can see how these fit inside the cutout.

Jules51

Awesome job and great workmanship!