Where are the grease pots?
#1
Super Member
Thread Starter
Join Date: Jul 2013
Location: Tri-Cities, WA
Posts: 1,063
Where are the grease pots?
Still working on my 99k - it's looking very good.[ATTACH=CONFIG]511038[/ATTACH] The last thing I want to do is put grease in the motor, but I don't see where to put it in. These pics show both sides:
[ATTACH=CONFIG]511039[/ATTACH] [ATTACH=CONFIG]511040[/ATTACH]. Can anyone give me some help on this? I've looked up "grease motor" but all the threads have so many posts to go through - didn't find anything that looked like this motor.
The motor works, the needle bar goes up and down, just need the motor greased then I'll wind a bobbin and try to actually sew on it!
[ATTACH=CONFIG]511039[/ATTACH] [ATTACH=CONFIG]511040[/ATTACH]. Can anyone give me some help on this? I've looked up "grease motor" but all the threads have so many posts to go through - didn't find anything that looked like this motor.
The motor works, the needle bar goes up and down, just need the motor greased then I'll wind a bobbin and try to actually sew on it!
#2
Super Member
Join Date: Aug 2011
Location: Millville, NJ
Posts: 1,835
No grease pots on this motor. Oil if any would be sparingly used on both ends of motor shaft bearings being careful not to get any on brushes, armature, and commutator. Singer was fairly unique in using melting "lube" to oil bearings and is not universally done. Good Luck.
Jon
Jon
Thread
Thread Starter
Forum
Replies
Last Post
sew_lulu
General Chit-Chat (non-quilting talk)
30
05-08-2010 09:57 PM
craftybear
General Chit-Chat (non-quilting talk)
26
04-22-2010 01:49 PM